Curbell CareSense CSM-PM100 Quick Setup Manual

CSM-PM100 QUICK SETUP GUIDE

Setup

Remove the plastic film from face of the
1
monitor, and install batteries.

Use

Confirm that the green "IN USE" light is flashing.
1
Attach the linen clip to the patient's clothing
4
(out of the patient's reach)
Adjust the volume control in the battery
2
compartment, close the cover, and
tighten the screw
TEST THE ALARM: Remove the magnetic
2
dome from the socket. The alarm will sound,
and the red "ALARM" light will flash.
Adjust the string to a length that will pull out
5
the magnetic dome to activate the alarm if the
patient attempts an exit.
NOTE: Consult the "Directions For Use" included with monitor for
complete instructions, troubleshooting, and safety information
Attach the Velcro strap.
3
Secure the monitor to back of the patient's
3
chair or bed.
CONNECTING TO NURSE CALL: Plug a Nurse
6
Call Connection Cable into the "NURSE CALL"
socket on the monitor, connect the opposite
end of cable into Nurse Call Station (an adaptor
may be required) and test.
www.curbellmedical.com • 1-888-222-2188
©2015 Curbell Medical Products, Inc. MAP1212B