Summary of Contents for Man&Tel MT-3000
- Page 1 MT-3000 Mobile Telecom. Trainer [MT-3000] User manual March. 2009 Man & Tel Co., Ltd. Man & Tel www.manntel.com <1/7 >...
-
Page 2: System Configuration
MT-3000 1. System configuration SYSTEM CONNECTION DIAGRAM 2. POWER Supply 1) Connect adaptor output terminal to the jack on the power board. 2) Connect adaptor Input Terminal to the Power board. Adaptor supply voltage is 110~240V 50~60Hz input, 9V 300mA output and center positive. -
Page 3: Basic Setting
MT-3000 Basic setting 1) Manual Mode This mode is used for a detailed board level experiment or for a manual mode experiment using Key Matrix on Control board – such as channel selection, voice communication, transmitting power on/off, audio mute, data transmitting. - Page 4 MT-3000 2) AUTO 모드 Under this mode, system will operate just like a real commercial product. Following diagram shows system component for a motion experiment under auto mode. Operating sequence is as follows; Identification code between BS and MS should be matched. It can be done with 4 bit dip switch on the Control board.
- Page 5 MT-3000 ⑤ If MS[BS] receive same ID code from BS[MS] then MS[BS] became ringing. ⑥ After ringing, user of MS[BS] press “Talk” button and pick up the handset and can make voice communication between BS[MS]. At this stage, the SIG/MIC switch direction should be at“MIC”.
- Page 6 MT-3000 press “Try Connecton” button. Then, the ring like beep sound up. ⑥ Set channel from round circle(named NOVE) which is shaped like the watch locating at top right corner on window screen. [ Caution : Don’t set the channel manually using the control...
- Page 7 MT-3000 =========================================================================== Records of Change Date Revision Reason for Change Man & Tel www.manntel.com <7/7 >...