No part of this work may be reproduced or used in any form or by any means (graphic, electronic or mechanical) without written permission from Net2Edge. The information contained herein is confidential property of Net2Edge Limited. The use, copying, transfer or disclosure of such information is prohibited except by express written agreement with Net2Edge Limited.
QSG | Quick Start Guide: PB-ISDN Introduction This document is a basic guide for configuring a new Net2Edge PacketBand ISDN. A full User Manual for configuring all settings on the unit is supplied on the DbManager Installation Disk. Applications The PacketBand ISDN range allows the delivery of synchronous ISDN, across asynchronous IP networks.
QSG | Quick Start Guide: PB-ISDN Getting Started This section will describe how to make the physical connections between PacketBand ISDN Chassis and the other system devices, and install the Net2Edge management application, DbManager. 4.1 Standard Accessories The following accessories are supplied with the PacketBand ISDN:...
QSG | Quick Start Guide: PB-ISDN Warning: The -48VDC power terminals are marked 0V, -48V, and GND. Net2Edge -48VDC products are designed for use with negative voltage DC supplies, and therefore expect the positive voltage to be connected to the 0V terminal, and the negative connected to -48V.
5.1 Connecting to the PacketBand ISDN Chassis Start up the DbManager Application Login as Super User (no password required) Four windows will be displayed: A network map showing Nodes and Links between Net2Edge devices A view of the communications Terminal between DbManager and...
Page 8
Info: TCP/IP management requires TCP port 3001 (dec) to be open between the management PC and PacketBand ISDN Chassis. Any switches, hubs or routers must be configured to allow communication on this port in order to manage the PacketBand ISDN Chassis via TCP/IP. www.net2edge.com...
Warning: When loading existing configuration files to a unit, please ensure that the correct configuration files are used for the unit type in use. PacketBand ISDN Chassis configuration files are not compatible with other Net2Edge products. 5.3 Device Settings This menu controls unit-specific features of the PacketBand ISDN such as the IP Address, Identifier, Serial Number, Configuration Number, Time &...
Flashing five times/sec: Layer 1 established, trying to synchronize with Layer 2 Calls active on interface Click on an enabled PRI port. The configuration settings for the port are displayed. Configure the settings as required for the port. Click OK to save the settings. www.net2edge.com...
1, 2.2 for PRI 2 Channel 2) Configure a group and select it from the Drop-Down To use a Group: menu To use a Logical Enter the Logical Link number (101 for Logical Link 101, 164 for Logical Link 164) Link: www.net2edge.com...
All configured routing profiles are displayed. Right click on a profile in the Type column to display options. The profile can be promoted or demoted in the priority list. There are also options to edit and delete the profile. www.net2edge.com...
PacketBand ISDN Chassis User Manual. The above settings are all that is required to get a Logical Link running initially. A pair of PacketBand ISDN Chassis working in a system should have identical Logical Link settings in order to pass traffic across a PSN. www.net2edge.com...
Chassis is complete. To upload, go to File Upload and wait until the progress bar completes. 5.11 Additional Resources All Net2Edge products and the DbManager application have their own User Manuals which can be found in the 'Documents & Manuals' folder on the DbManager installation disk or by registering at the Net2Edge website: www.net2edge.com...