Summary of Contents for Mainlink MK-V0107
- Page 1 WI RE LE SS HD VID EO TRA NS MI SS IO N INTRODUCTION ／INSTRUCTION ／INSTALLATION GUIDE 版本：V3.0（2018.09）...
-
Page 2: Table Of Contents
Catalogue 1、Disclaimer----------------------------------------------------------------------1 2、Announcement ----------------------------------------------------------------1 2.1 Installation Warning----------------------------------------------------------1 2.2 Usages warning ---------------------------------------------------------------1 3、Product profile-----------------------------------------------------------------2 4、Description ------------------------------------------------------------------2 4.1 Transmitter --------------------------------------------------------------------2 4.2 Receiver -----------------------------------------------------------------------3 4.3 Accessory----------------------------------------------------------------------3 5、Wiring installment------------------------------------------------------------4 5.1 Carrier connection diagram-------------------------------------------------4 5.2 Receiver connection diagram-----------------------------------------------5 6、Usages -------------------------------------------------------------------------5 6.1 Channel settings --------------------------------------------------------------5 6.2 transmitter net pull address setting-----------------------------------------6 6.3Video record--------------------------------------------------------------------6 7、Working indicator-------------------------------------------------------------6 7.1 Transmitter indicator----------------------------------------------------------6... -
Page 3: 1、Disclaimer
ShenZhen MainLink Aero communication Technology Co., Ltd and its affiliated companies will not hold any legal liability. The copyright of this user manual is belongs to ShenZhen MainLink Aero communication Technology Co., Ltd. All rights reserved. No reproduction shall be made in any form without permission. -
Page 4: 3、Product Profile
4. Please ensure that there is no interference in the environment with the same frequency or high RF power wireless transmission equipment, otherwise the receiver may not receive the video normally. 5. If the signal of the Receiver is poor, try to change the direction of antenna（receiver）. 6. -
Page 5: Receiver
4、Antenna interface A4：CH3 usage status indicator 5、Power interface B1：VCC（DC 9～28V） B2：GND Receiver 1、Antenna interface 2.1、Power indicator 2.2、Signal indicator 3、Channel switching switcher 4、Recording switch 5、Power input B1、VCC（DC 9～28V） B2、GND 6、USB interface 7、HDMI interface Receiver antenna Transmitter antenna Antenna ×2 Whip antenna ×1 Accessory IP ×1... -
Page 6: 5、Wiring Installment
Installation and wiring Take Mutiple-rotor UAV for an example: Connection diagram ： Fix the transmitter on the suitable space of drone(by 3M strap) as follow, and then install antenna vertical down. Next, connect camera and transmitter with HDMI cable (or with CVBS cable), and then Power On. -
Page 7: Receiver Connection Diagram
Receiver connection diagram Connect the HDMI of receiver to LCD display. And connect the antenna ,fasten it. Installation notes： 1.Keep the antenna away from metal equipment of drone, and the antenna should have wide space within 20cm to other objects to ensure efficient transmission; 2.Make a proper planning about frequency of all wireless equipment on UAV. -
Page 8: Transmitter Net Pull Address Setting
receive four videos: CH1-HDMI,CHI1-IPC, CH2-HDMI,CHI2-IPC. Setting up the address of pulling stream at transmitter network The network port input of the transmitter supports RTSP IP cameras. The default stream address of the transmitter is rtsp://192.168.1.100:554/stream0, and the network flow can only be available when IP address (192.168.1.100) and port (554) are both correct. -
Page 9: 8、Specification Parameter
LED indicator Transmitter status Description PWR: A1 CH1: A2 CH2: A3 Power on: Green Power on, device initialization Completed initialization, video source input not Green(blink) detected Working: Green(all the time) Working properly, video source input Indicates current channel, corresponding to A2、A3 One of light : Green CH1/CH2... -
Page 10: 9、Dimension Diagram
Range Distance 10km@ Output power >1W 50km@ Output power >5W Weight About 98g Dimension 82*62*24mm HD video receiver Product Model MK-V0107 Frequency 300~900MHz (can be customized) Antenna interface 50Ω SMA female head Voltage DC9~18V Video input interface HDMI（type A） Reception Sensitivity <-96dBm... -
Page 11: 10、Faq (Frequently Asked Question)
FAQ (frequently asked question) Questions Possible reason Solution ●Check that whether the transmitter is ●Unturned transmitter properly installed and powered on ●Close input video source, restart transmitter, ●Abnormal decode OLED Output no until signal of receiver is normal, then turn transmitter, is closing down signal on video source again... - Page 12 antenna connect fastening, if applicable, Close range test output power of transmitter is communica normal or not tion， video ●Please try to use Gopro as video source ●Video format of video source first, check whether it is caused by video transmitter does smooth...