Advertisement
Replacing the lamp unit and air filter (continued)
5) Attach the air filter case to the
projector.
z Be sure to insert the air filter case fully and
securely.
6) Attach the lamp unit cover.
z See step 5 of the "Replacing the lamp unit"
section.
Attaching/removing the clasp
from the lamp unit
■ Attaching the clasp
Attach the clasp to the ventilation area of the lamp
unit.
Ventilation area
1) Place the clasp on the ventilation
area.
Clasp
2) Press the bottom side of the clasp
to slide it in.
z Press the clasp all the way in until it stops.
Tab
3) Verify that the clasp's tabs (left
and right) fit securely on the outer
frame of the ventilation area.
Attention
z When handling the clasp, gently hold it between
your fingers on the left and right sides. Grasping
the clasp from the top or bottom surfaces may
result in deformation.
z Do not press down on the metal mesh of
the ventilation area. Doing so may result in
deformation.
z Remove the clasp from the lamp unit when
switching the installation to an orientation other
than downward-facing.
■ Removing the clasp
Slide the clasp off while lifting its tabs
(left and right).
z Use your nails, for example, to lift the tabs at their
raised top edges (i), and slide the clasp off of the
ventilation area's outer frame (ii).
Outer frame
ENGLISH-7
Advertisement
