Trouble Shooting - Hunter HDH-50K800 Use & Care Manual

Before calling for service, try the suggestions below .
Dehumidifier will not run
■ Is the dehumidifier turned on?
Turn on the dehumidifier.
AWARNING
Electrical Shock Hazard
Plug into a grounded three-prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire or electric shock.
■ Is the power cord plugged into a grounded three-prong outlet?
Plug into a grounded three-prong outlet. See Electrical Requirements.
■ Has a household fuse blown or has a circuit breaker tripped?
Replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician. See "Electrical Requirements."
■
Is the bucket installed properly?
Reinstall the bucket so that it fits all the way into the dehumidifier.
■
Does the bucket need to be emptied?
Empty the bucket.
■
Is the water level float in place?
Remove the bucket. Make sure the float is snapped
in place. Reinstall the bucket.

TROUBLE SHOOTING

Does the pump indicator light flash?
1. Check and make sure the drain hose is correctly connect to
2. Press the POWER button to turn off the unit. Restart the unit
10
Dehumidifier runs but does not dehumidify
■ All models have an automatic de-icing function that
will shut off the compressor and allow the fan to run.
When the de-icing function senses the correct operating
temperature,the compressor will cycle back on.
■ Is the control set to Continuous?
If you have selected Continuous Run, the dehumidifier
will run continuously. If the room humidity level is low,
little or no water may be collected.
■ The filter is dirty or obstructed by debris.
Clean the filter.
Air coming from the dehumidifier is warm
■
Dehumidifier will put out warm air under normal
operating conditions.
Dehumidifier displays error codes
■
If the dehumidifier displays an error code, please
conta ct Hunter customer service at 1-855-887-1440.
Pump system does not work
the unit.
by pressing POWER button again.