TLC Datalogic Gryphon GM4100 Series Programming Manual

Advertisement

Quick Links

GM4100 Syncing

When using the Gryphon™ GM4100 (wireless) series scanner, after scanning any barcode in this
document (except when advised to scan both barcodes before syncing), and before proceeding
with the scanning task, return the scanner to its base to allow the base to sync with the scanner.
During the sync process lights will flash on the scanner base. When the lights stop flashing the
sync is complete. The sync process typically completes in 10-15 seconds.

Before You Begin

If the GM4100 (wireless) was previously linked to another base you must first scan
Important!
the Unlink barcode at the end of page 2.
Whether or not you needed to scan the Unlink barcode, before you begin using either model
scanner you must first scan the Interface USB Keyboard EM barcode below.

USB Keyboard Emulator

Note: If using the GM4100 (wireless) unit, scan the Interface USB Keyboard Em. barcode
below and return the unit to the base to sync.
After the sync is complete scan the appropiate function barcode on the following pages, taking
note of the barcode's accompanying instructions.

Disable Carriage Return

By default, Carriage Return <CR> is enabled. This function should remain enabled if using
the scanner for circulation purposes. To use the scanner with L.S Cataloging, you may wish
to disable Carriage Return.
Note: If using the GM4100 (wireless) unit, scan the appropriate barcode before returning the
scanner to the base to sync.
.

Enable Carriage Return

Datalogic Gryphon™ GM4100 / GD4100 Series: Programming Guide – March 29, 2012
GM4100 / GD4100 Series – Programming Guide
Interface USB Keyboard Em.
³
$
P
,
H A
Suffix = none
³
$ P
,
C L F S U 0 0 0 0
Suffix of CR
³
$ P
,
C L F S U 0 D 0 0
Datalogic Gryphon
3
5
,
P
,
P
,
P
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Datalogic Gryphon GM4100 Series and is the answer not in the manual?

Questions and answers

Summary of Contents for TLC Datalogic Gryphon GM4100 Series

  • Page 1 Datalogic Gryphon ™ GM4100 / GD4100 Series – Programming Guide GM4100 Syncing When using the Gryphon™ GM4100 (wireless) series scanner, after scanning any barcode in this document (except when advised to scan both barcodes before syncing), and before proceeding with the scanning task, return the scanner to its base to allow the base to sync with the scanner. During the sync process lights will flash on the scanner base.
  • Page 2  Enable Codabar Scanning Scan both barcodes below. Note: If using the GM4100 (wireless) unit, scan both barcodes before returning the scanner to the base to sync. Enable Codabar Codabar Start/Stop Transmit Disable ’’ ³ C C B E N 0 ³...

This manual is also suitable for:

Datalogic gryphon gd4100 series

Table of Contents