Advertisement
M650H Solar Marine Light
The NexSens M650H 4 Nautical Mile Solar Marine Light is designed for mounting to
CB-650, CB-950, and CB-1250 data buoys per U.S. Coast Guard requirements.
IR Remote Programmer
Powering on the beacon
Activate the beacon by entering the passcode sequence
a. The main LED will flash once with each registered keypress.
b. Three quick flashes following a sequence indicate that the command was
accepted.
c. Two slow flashes following a sequence indicate that the command was
refused. Carefully re-enter the command and retry.
Once the passcode is accepted, turn on the beacon by setting a flash code.
The default NexSens-configured flash code is
a. The beacon will flash with the designated pattern for 60 seconds after the
code is accepted. It will resume flashing when low ambient light is
detected.
Quick Start Guide
1
2091 Exchange Court
Fairborn, Ohio 45324
937-426-2703
www.NexSens.com
Advertisement
Table of Contents
Summary of Contents for NexSens M650H
- Page 1 M650H Solar Marine Light Quick Start Guide The NexSens M650H 4 Nautical Mile Solar Marine Light is designed for mounting to CB-650, CB-950, and CB-1250 data buoys per U.S. Coast Guard requirements. IR Remote Programmer Powering on the beacon Activate the beacon by entering the passcode sequence a.
- Page 2 M650H Solar Marine Light Quick Start Guide Checking the battery charge 1. Enter the passcode sequence on the IR programming remote 2. Send the battery SOC (state of charge) command 3. Once the sequence is entered, the beacon will quickly flash 3 times to acknowledge the command.
Need help?
Do you have a question about the M650H and is the answer not in the manual?
Questions and answers