Xiaomi Huahuacaocao HHCCJCY01HHCC Quick Start Manual

Xiaomi Huahuacaocao Flower
Plants Smart Monitor
Overview
Learn how to care of a variety of plants, connecting Flower
Plants Smart Monitor to your phone. Real-time check and
control a light level, temperature, soil moisture and its
fertility. Provide the most comfortable conditions for your
plants.
Presence of device
Light sensor
Temperature sensor
Soil moisture sensor
Soil fertility sensor
Installing a software
This device is already included in Mi
Smart Home list of devices, supports
MIUI system and can interface with
other smart devices in your home.
You can use the normally installed
standalone version.
Install a standalone version for iOS /
Android by scanning QR code.
Using the device
1. Open rear Smart Monitor panel, remove an
insulating sheet from a battery compartment and close
a back cover.
2. Insert Smart Monitor in a flower pot. If a ground soil
is too dry, pour it and insert the device.
3. Turn on Bluetooth on your
smartphone, in upper right corner of
Mi Smart Home interface, click on
«+».
Add Flower Monitor in Mi Smart
Home list of devices, guided by the
instructions of the application.
(Double blinked light sensor indicates
successful connection of devices).
Caution
Before installing Flower Monitor in the ground, be sure to
clean an outer surface of the device.
Insert soil moisture sensor in the ground not less than 2/3.
Ensure maximum exposure to the top of the unit.
Check for absence of water on a soil moisture sensor.
More cautions
This device has a battery
1. Do not store batteries in locations, easily accessible to
children.
2. If the device has been exposed to rain or dropped into
water, it can cause it to break.
3. Do not heat, squeeze or damage battery components.
4. If a battery ran down, or has not been used for a long
time, remove it and dispose of in accordance with local legal
provisions on the disposal or recycling of batteries.
5. Before changing a battery in the device, pay attention to
the type of batteries indicated in manual.