Bio Spectra 24 User Manual

Radiant heat panel

Advertisement

Radiant Heat Panel
Spectra 18, 24 and 32
User Manual
[Revision 1.0 June 2018]
READ THIS MANUAL CAREFULLY BEFORE USE – FAILURE TO DO SO MAY RESULT IN INJURY, PROPERTY
DAMAGE AND MAY VOID WARRANTY. • KEEP THIS MANUAL FOR FUTURE REFERENCE. • Products covered by
this manual may vary in appearance, assembly, inclusions, specifications, description and packaging.
E&OE
© 2018 Bio

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Spectra 24 and is the answer not in the manual?

Questions and answers

Summary of Contents for Bio Spectra 24

  • Page 1 READ THIS MANUAL CAREFULLY BEFORE USE – FAILURE TO DO SO MAY RESULT IN INJURY, PROPERTY DAMAGE AND MAY VOID WARRANTY. • KEEP THIS MANUAL FOR FUTURE REFERENCE. • Products covered by this manual may vary in appearance, assembly, inclusions, specifications, description and packaging. E&OE © 2018 Bio...
  • Page 2: Safety

    / collection facilities, only, and far away from windows, doors • For specific equipment safety use and ensure these are connected and used and vents. care, see Equipment Safety. properly. Dust collection can reduce dust-related hazards. E&OE © 2018 Bio...
  • Page 3 • We are not responsible for incorrectly chosen fixing accessories or any damage which may be caused by an incorrectly fitted wall heater. • If required 15AMP power points must be installed by a qualified electrician. E&OE © 2018 Bio...
  • Page 4: Specific Safety Instructions

    Always follow the Australian requirements for connection to the mains supply. If in doubt always consult a qualified electrician. Note: (3200W) requires installation of a 15AMP socket by a qualified electrician before use. E&OE © 2018 Bio...
  • Page 5: Safety Symbols

    Wear appropriate Always wait for moving parts injury to fingers, limbs, blood clothing and protectiove to stop fully before handling etc. Take due care when devices. the product, adjusting, handling and using the maintenence etc. product. E&OE © 2018 Bio...
  • Page 6 Carry hook to load – do NOT Wear appropriate eye Laser may be in use – do NOT throw or run. protection for welding. Dorect look directly at laser, or allow exposure to weld arcs may others to. cause permanent eye injury. E&OE © 2018 Bio...
  • Page 7: Table Of Contents

    Adjusting the Bracket Position ........................9 Tilting the Head ............................9 Heater Positioning ............................ 10 Operation ............................11 Maintenance ............................. 11 Specifications ........................... 12 Spectra 18 ..............................12 Spectra 24 ..............................12 Spectra 32 ..............................12 E&OE © 2018 Bio...
  • Page 8: Assembly

    6. Heater is now mounted and ready for use. Check the safety distance between the heater body and flammable surface when wall or corner mounted. Do not mount the heater in the ceiling, always mount to the ceiling, see Heater Positioning. E&OE © 2018 Bio...
  • Page 9: Adjusting The Bracket Position

    4. Tighten the head tilt bolt when the desired angle is achieved. 5. Insert and tighten the locking bolt if possible to stop any unintentional movement of the heater. Note: If locking bolt cannot be fitted, ensure the head tilt bolt is very tight. E&OE © 2018 Bio...
  • Page 10: Heater Positioning

    4. If heater is facing another vertical surface, e.g. a wall, the gap must be at least 1 metre. 5. Never mount heater within 1 metre of a water source, e.g. a tap. Never mount heater into the wall or ceiling. Only mount to the surface. E&OE © 2018 Bio...
  • Page 11: Operation

    NEVER allow water or a mild dish washing solution to enter or drip onto the wall heater. NEVER use solvents, e.g. Petrol, Toluene, Methylated Spirits etc. to clean the floor heater, as these will damage the surface finish and may cause a fire when unit is next used. E&OE © 2018 Bio...
  • Page 12: Specifications

    240V AC IPx4 rated Splash Resistant Cord Length 1.5m Plug Standard 3 pin 15 Amp Power Plug Australian Standard NOTE: The 3200W Bio Electric Radiant Strip Heater requires installation by a licensed electrician to a 15A circuit E&OE © 2018 Bio...
  • Page 13 ©2018 Bio. All rights reserved. No part of this document, including descriptive content, concepts, ideas, diagrams or images may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopying, scanning or recording, or any information storage and retrieval system, without express permission or consent from the publisher.

This manual is also suitable for:

Spectra 18Spectra 32

Table of Contents