Useful Features; Switching The Weight Mode; Automatic Shut-Down Function - Tanita BF-626W Instruction Manual

GB

USEFUL FEATURES

• Tanita Body Fat Monitor/Scales allow you to measure both weight and body fat percentage simultaneously and easily,
simply by stepping on a scale.
• Your Body Fat Monitor/Scale can be set for Male or Female, Standard or Athlete Adult, or Children (ages 7-17).
• Personal data (Female/Male, Age, Height, etc.) can be pre-set and stored in memory for up to two people.
• Unique Healthy Range Indicator automatically displays where your body fat percentage falls within the Body Fat Ranges chart (p.2).
• The unit emits a helpful "beep" when activated, and also at various stages in the programming and measuring process.
Listen for these sounds which will prompt you to step on the unit, look at your readings, or confirm a setting.

SWITCHING THE WEIGHT MODE

Your Body Fat Monitor/Scale can measure weight in three different modes: st-lb (British stone-pounds), kg (kilograms), or
lb (pounds). If you would like to change that setting, or if at any point another setting has been inadvertently entered,
follow these steps:
1.Press the Set and Up buttons simultaneously. Release the buttons, the
display will flash.
2.Press the Up button to cycle through each weight mode until
the mode that you require is displayed.
3.Then press the Set button. The unit will beep twice in short succession,
and the display screen will flash to confirm your selection and store it in
memory.
Note: If weight mode is set to pounds or stone-pounds, the height programming mode will
be automatically set to feet and inches. Similarly, if kilograms is selected, height
will be automatically set to centimetres.

AUTOMATIC SHUT-DOWN FUNCTION

The automatic shut-down function shuts off the power automatically in the following cases:
• If you interrupt the measurement process. The power will shut down automatically within 10 to 20 seconds,
depending upon the type of operation.
• If an extraordinary weight is applied to the platform.
• If you make a mistake during measurement or a key or button operation.
• During programming, if you do not touch any of the keys or buttons within 60 seconds.
• After you have completed the measuring process.
Note: If the power shuts off automatically, repeat the steps from "Setting and Storing Data in Memory" (p.5).
5