Table of Contents
Advertisement
Quick Links
Instruction Manual
&
Parts Catalog
Read and understand this entire manual before operating or
servicing this product.
Copyright
2011 by ArcPro. All rights reserved. No portion of this manual or any artwork contained
c
herein may be reproduced in any shape or form without the express written consent of ArcPro. Due to
continuing improvements, actual product may differ slightly from the product described herein.
SAVE THIS MANUAL
Auto Darkening
Welding Helmet
Model 20702
Advertisement
Table of Contents
Summary of Contents for ArcPro 20702
- Page 1 2011 by ArcPro. All rights reserved. No portion of this manual or any artwork contained herein may be reproduced in any shape or form without the express written consent of ArcPro. Due to continuing improvements, actual product may differ slightly from the product described herein.
- Page 2 Notify ArcPro immediately if any hidden loss or damage is discovered after receipt. Model 20702 Page 2...
- Page 3 -Damage to the reproductive organs cutting, laser welding, performing Oxy- -Inflammation of the small intestine or acetylene welding/cutting, or for over- stomach head welding. -Kidney damage D. ANSI (American National Standards Institute) defines all welding helmets as Model 20702 Page 3...
- Page 4 When welding or when in close proxim- ity to a welding operation, always wear --- Adjustment Knob a welding helmet fitted with the proper shade to protect yourself. Underneath the helmet, always wear ANSI approved safety goggles with side shields. Model 20702 Page 4...
- Page 5 See photo upper right. The LOW position is best for higher amper- age welding and for welding in bright light conditions. The HIGH position is designed for low am- perage welding and when welding in lower light conditions. Model 20702 Page 5...
-
Page 6: Troubleshooting
After cleaning, dry the helmet with a clean cloth. Limited Warranty ArcPro warrants to the original retail purchaser 3. Replace the Front Cover Lens when it that the product is free of defects in material becomes cracked, scratched or damaged in and workmanship at the time of shipment. - Page 7 Some parts are listed and shown for illustration purposes only, and are not available as replacement parts. All repairs to this tool (including replacing parts) should only be done by a qualified service technician. Model 20702 Page 7 Model 20702...
Need help?
Do you have a question about the 20702 and is the answer not in the manual?
Questions and answers