Advertisement
terminal.
Connecting the Antenna
Connect the vehicle's antenna cable to the antenna jack on the back of the
stereo.
Completing and Testing the Connections
Make sure you have securely made all other connections, then plug the
harness' connector into the stereo's 14-pin wiring socket.
cable to the vehicle's negative (-) battery terminal.
Install your stereo's control panel (see "Installing the Control Panel")
and turn on your vehicle's ignition, the stereo's clock display light,
then press PWR.
If the stereo does not work, immediately disconnect the cable from your
vehicle's negative (-) battery terminal.
After you verify that the buttons/display light, follow the instructions
in "Mounting the Stereo" below.
CAUTION:
If you played a CD while testing the connections, be sure to
remove the CD from the stereo before continuing.
Using the Control Panel
The stereo's control panel must be installed for the stereo to operate.
When you remove it, the stereo will not operate.
effective security measure.
control panel is removed.
Installing the Control Panel
1.
Insert the left edge of the control panel into the left edge of the
recess.
The hole in the control panel interlocks with the tab in the
recess.
2.
Gently push the right edge of the control panel into the recess until
you hear a click.
Removing the Control Panel
1.
Press REL on the right side of the control panel.
swings out.
Then recheck your connections.
Any stored stations remain in memory when the
Reconnect the
This is a simple but
The control panel
Advertisement
