Definitive Technology StudioSlim Setup Manual page 20

Safety Precautions
FCC Statement
COMPLIANCE INFORMATION
Product Name: 3.1 Home Theater Sound Bar and Wireless
Subwoofer System
Model Number: Studio Slim and Studio Slim Subwoofer
CONTAINS TRANSMITTER MODULE FCC ID: IPUJMDD
FCC ID: IPUSTUDIOSLIM (BAR) FCC ID: IPUSTUSLIMSUB
(Subwoof er)
1. This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1) This device may not cause harmful interference, and
2) This device must accept any interference
received, including interference that may cause
undesired operation.
2. Any Changes or modifications not expressly approved
by the party responsible for compliance could void
the user's authority to operate the equipment.
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment
and receiver.
- Connect the equipment into an outlet on a circuit
different from that to which the receiver 1s connected.
- Consult the dealer or an experienced radio/TV
technician for help.
FCC RF Radiation Exposure Statement
1. This transmitter must not be collocated or operating
in conjunction with any other antenna or transmitter.
2. This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled
environment. This equipment should be installed and
operated with minimum distance 20cm between the
radiator & your body.
3. FCC RF Warning
This equipment must be installed and operated in
accordance with provided instructions and the antenna(s)
used for this transmitter must be installed to provide a
separation distance of at least 20 cm from all persons and
must not be co-located or operating in conjunction with
any other antenna or transmitter. End-users and installers
must be provided with antenna installation instructions
and transmitter operating conditions for satisfying RF
exposure compliance.
IC RF Radiation Exposure Statement
CONTAINS TRANSMITTER MODULE IC: 10392A-JMDD
IC: 10392A-STUDIOSLIM (BAR) IC: 10392A-STUSLIMSUB
(SUBWOOFER) This device complies with the Canada
portable RF exposure limit set forth for an uncontrolled
environment and are safe for intended operation as
described in this manual. The further RF exposure
reduction can be achieved if the product can be kept as
far as possible from the user body or set the device to
lower output power if such function is available.
Canada, Industry Canada (IC) Notices
This Class B digital apparatus complies with Canadian ICES-
003. To reduce potential radio interference to other users,
the antenna type and its gain should be so chosen that the
equivalent isotropically radiated power (e.i.r.p.) is not more
than that permitted for successful communication.
This device complies with Industry Canada license-
exempt RSS standard(s).