Taking Into Operation; Setting Temperature; Three Year Warranty - EHEIM 3603 Manual

The product is approved in accordance with
the respective national regulations and
guidelines and complies with the EU
standards.
Do not dispose of this product as normal
household waste. Take it to your local refuse
collection site.

Taking into operation

- Check device for damage.
- Remove transit protection.
- Fix suction cups
holder
- Mount thermostatic heater with double suction
cup holder
it in a place where water flow is brisk
(filter out-lets/vents).
- Plug into mains socket.
C Check that drip loop

Setting temperature

B
Turn the temperature selector ring
desired temperature. Monitor the aquarium
water temperature using an accurate thermo-
meter for at least 24 hours and make any
necessary adjustments to compensate for
calibration errors. You should periodically
monitor your aquarium water temperature with
an accurate thermometer.
(„Red light"
Note: The temperature selector ring should only
be used as a guide. Always use an
accurate thermometer for water tempera-
ture measurement.
Ratings (see table)
These are standard ratings are for closed aquariums
with an ambient room temperature of 21°C
and a desired water temperature of up to 26° C.
Three-year warranty
Does not cover breakage or damage to glass, improper
use or improper re-calibration and is voided if the device
is opened.
Re-Calibration & Re-Calibration
Procedure
Diagram B
Under normal operation, re-calibration of your
Jäger heater will not be necessary. Re-
calibration should not be attempted if you do
not have an accurate thermometer or are not
confident that you are able to carry out the
re-calibration procedure. Incorrect re-
calibration of heaters is not covered by
warranty.
If after a day or two in operation the water
temperature does not correspond with the
temperature shown on the temperature
selector ring and you wish to re-calibrate
the heater so that the measured temperature
corresponds to the selected temperature you
need to follow the procedure listed below.
- The heater must remain submersed in the
to double suction cup
and clip onto heater
vertically in the aquarium, fixing
= heater in operation).
6
is in position!
to the