Table of Contents
Advertisement
3.2 INSTALLATION OF THE SUPPORT PLATE
A- After deciding on the position of the internal unit, position the support plate according
to the overall dimensions of the unit and referring to the measurements on the drawing
GB
opposite.
B- Mark and dot punch the six 5 mm dia. fixing holes.
C- Make the hole for the pipes (see § 4.2):
- either by removing the cover (see sketch) for pipes entering through the side,
- or by positioning the 80 dia. hole (lining up on the arrow) and by making it (see
3.3) for pipes entering through the rear of the handler.
D- Drill the six 32 mm deep, 5 mm dia. fixing holes.
E - Put the 6 plugs in the 5 mm dia. holes.
F - Fix the support plate on the wall using the six 4 x 16 screws.
MW 2
MW 3
Guide arrows
80 mm dia. hole
MW 4
MW 5
Guide arrows
D
Ø 5
E
8
20
105
35
155
60
Hole Ø 80 mm
F
32
Support plate
800
380
760
1 000
cover
75
20
Advertisement
Table of Contents
