Table of Contents
Advertisement
Compute Module IO Board Plus User Manual
HOW TO USE
INSTALLATION
CM3/CM3+
If you use Compute Module 3 or Compute Module 3+, you need to write OS image to the
embedded EMMC, otherwise they cannot work. Here show you how to write image to EMMC
1.
Pull the jumpers of USB SLAVE 1/2/3/4 SELECTION (you need to pull two jumpers
here), set the BOOT ENABLE USB SLAVE jumpers to EN position.
2.
Install USB driver. Run the software
of wiki) to install the drivers and boot tool.
3.
Connect 5V power adapter to Power interface, plug the USB SLAVE port of IO Board
Plus into your host PC USB.
4.
Run the rpiboot.exe tool. After a few seconds, the CM3 eMMC will be recognized as a
disk.
5.
Run WinDiskImager.exe tool to burn the image to eMMC of CM3.
Note:
Ensure you are not writing to any USB devices while installation.
Because the eMMC of CM3 is only 4G, the image file flashed should be small than 4G. If you
want the GUI, you can install it with these commands after installation
sudo apt-get update
sudo apt-get install raspberrypi-ui-mods
CM3L/CM3+ L
1.
Download the image for CM3L
2.
Connect the SD card to computer with card reader. The capacity of SD card should
larger than 8G.
3.
Run the Win32DiskImager.exe, choose the CM3L image and burn it to SD card.
4.
After burning successfully, insert the card to the card slot of IO Board Plus
Version：V1.0，Date：20171101
rpiboot_setup
(You can download it from Resource
7
Advertisement
Table of Contents
