simpl PhotoPhone User Manual page 2

USING THE PHONE
MAKE A CALL/ REDIAL
- Pick up the handset or press 'DIAL ' orange key.
- Dial the number or press one of the 6 Photo keys (with pictures). See
paragraph 'Store number'.
• If someone answered and you pressed DIAL
handset and have your conservation. (not for typical speakerphone
conversations - microphone works from less than 12 inches only)
• If no one answered hangup the handset or press the DIAL
again to hang up.
At the end of the communication:
- Hang up by replace the handset on its base
DIAL BACK AN OUTGOING NUMBER
- Pick up handset or press key.
- Press key.
REDIAL
ANSWERING A CALL
- To answer:
Pick up the handset or press
- To end a call:
Replace the handset on its base or press
HANDSET/EAR-PIECE VOLUME ADJUSTMENT
- Press V to increase the volume level.
V
O
O
L
L
+
+
V
- Press to decrease the volume level.
V
O
O
L
L
-
-
- 4 levels selectable.
STORING NUMBERS FOR (6) PHOTO BUTTONS
- Pick up handset.
- Select one picture key, and long-press it for a few seconds until you
hear a 'beep'.
- Enter the number by using keypad. (3-second pause (one press) may be
required when entering a sequence of numbers for photo button dialing
in facilities.)
- Press again the same picture key.
The number is registered.
FLASH TIME
The Flash key engages the call waiting feature, if available form your
service provider, allowing you to accept a second incoming call. Flash
time is the amount time (under 1 second) to switch from one call to
another. Flash time adjustment may be required if installing the phone
in a facility. (based on system requirements).
If an adjustment is required:
- / *#*100 /
FLASH
- / *#*300 /
FLASH
- / *#*600 /
FLASH
- / *#*1000 /
FLASH
button, then pick up
key. (handsfree mode).
key.
= 100ms
= 300ms
= 600ms
= 1000ms
SAFETY
Do not use your telephone to notify a gas leak or other potential explosion
hazard.
Do not open your device to avoid risk of electrical shock.
Your telephone must be located in a dry place away from hot, humid and
direct sunlight condition.
ENVIRONMENT
button
This symbol means that your inoperative appliance must be
collected separately and not mixed with the household waste.
Help us to protect the environment in which we live!
REGULATORY COMPLIANCE
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
To assure continued compliance, any changes or modifications not expressly
approved by the party responsible for compliance could void the user's authority
to operate this equipment. (Example- use only shielded interface cables when
connecting to computer or peripheral devices).
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Caution! Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
FCC - PART 68
This equipment complies with Part 68 of the FCC rules and the requirements
adopted by the ACTA. On the bottom of this equipment is a label that contains,
among other information, a product identifier in the format US:C70-56010. If
requested, this number must be provided to the telephone company. This
equipment uses the following USOC jacks: RJ-11.
3 4