Aquatic AQ-RF-6UBT Series Instructions

AQ-RF-6UBT
WATERPROOF REMOTE CONTROL
Contents
Please check first that the package contains all of the items below. If something is missing,
contact the store where you purchased the product.
• Remote Control RF Handset (AQ-RF-6UBT-T)
• RF Receiver (AQ-RF-6UBT-R)
• Charging Cable
Charging the Remote Control
The remote has a built-in Polymer Lithium rechargeable battery and comes with a charging cable.
Connect one end of the charging cable to the charging connection on remote control and connect
the USB end of the charging cable to any USB charger (5V DC) for charging.
Make sure the remote has been charged before used.
Synchronizing the Remote Control
The remote should already be paired from the factory, but if you need to synchronize the remote,
follow the steps below.
1. Connect the receiver dongle to the female DIN connector of the Aquatic AV stereo before the
stereo is powered ON.
2. Turn the power to the stereo ON and hold the remote control close to the stereo.
3. Press and hold MODE on remote control until the LCD shows "Pairing in Progress" and then
release the button.
4. The remote's LCD should display "Paired" wIthin 2 seconds to verify pairing has been suc-
cessful. If it fails to pair, the LCD will display "Retry again". If this happens, wait 5 seconds and
repeat the above procedures.
If the pairing process is not successful, try again to put your remote close to the remote receiver.
Depending on the frequency of usage, the remote may drain its battery. Please charge the remote before use. If the LCD
shows nothing, the battery has been drained and will need charging.
Aquatic AV, 282 Kinney Drive, San Jose, CA 95112, USA. info@aquaticav.com - US & Canada: 1 877 579 2782 - Int: +1 408 559 1668
PLEASE READ THESE INSTRUCTIONS
BEFORE OPERATION
www.aquaticav.com