Table of Contents
Advertisement
The local Ethernet port is also used to access the DA-400™ configuration menu where a
number of configuration options are available for selection and programming.
To connect to the DA-400™ with an Ethernet cable:
1.
Connect a computer or laptop via an Ethernet Cable to Ethernet Port 1 on the
DA-400™.
2.
Configure your computer or laptop Network Adaptor to connect to the DA-400™
with the network IP range of 192.168.1.XXX (the DA-400™ is 192.168.1.20).
3.
Open an Internet Browser on your computer or laptop and enter the IP Address
192.168.1.20 in the URL Browser bar.
NOTE: A password is not required to review the DA-400™ configurations.
3.10 CONFIGURATION REVIEW
a.
Unit Serial Number – This will display the Serial number assigned to the DA-
400™
b.
Listen Port – This is the assigned HTTP Port the DA-400™ is "Listening" to.
Eberle Design Inc.
®
iCITE
DA-Data Aggregator
Installation Manual
®
iCITE
DA-400™ and
®
13
Page
Advertisement
Table of Contents
