Advertisement
To Assemble Highchair
Step 1.
Hold front tube with ends up.
Place a foot (smooth side up)
at one curved corner of tube.
Insert a screw through tube
and into foot, then tighten.
Repeat with other corner,
then with both feet of rear
tube.
Step 2.
Lay seat face down on the
floor as shown. Insert
support tube through both
collars on bottom of seat.
Step 3.
Insert recline bar into one recline bracket (brackets
have “L” and “R” on inside), with curved side of bar
toward the bracket. Then attach bar and both recline
brackets onto each end of the support tube as shown.
Insert at end
Curved side of
recline bar
Step 4.
Insert both ends of upper
tube through holes in recline
brackets and pull all the way
through as shown.
Still holding ends of tube,
locate pegs. Push pegs
through the channel until
they pass the snap. Slide
pegs into first notch of
height-adjustment track.
5
231-3-99 IS3548
All manuals and user guides at all-guides.com
Collars
Support tube
“L” bracket
“R” bracket
“U” curve up
Pegs
First notch of
height-adjustment track
Step 5.
Hold rear tube as shown.
Slide plastic brackets onto
upper tube.
Plastic bracket
Step 6.
Slide front tube onto upper
tube as far as it will go, until
the holes in the tubes line up.
“U” curve
down
Step 7.
Pull rear tube up until holes
in plastic brackets line up with
holes in the tubes.
CHECK that holes in upper
tube, front tube AND plastic
brackets all line up with each
other.
Step 8.
Insert a T-nut into one plastic bracket hole. It must pass
through both tubes, as shown in closeup below.
Insert a screw into other side of
plastic bracket and screw it into
the T-nut.
CHECK that tubes are
securely connected by
trying to pull them apart.
Repeat for other plastic bracket.
Set highchair upright.
Both “U”
curves up
6
Advertisement
