Advertisement

Quick Links

denim brights
bouncing cradle
user guide
WARNING - Important
Keep for future reference

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Denim Brights and is the answer not in the manual?

Questions and answers

Summary of Contents for mothercare Denim Brights

  • Page 1 WARNING - Important Keep for future reference...
  • Page 2: Parts Checklist

    introduction This bouncing cradle is designed for babies who cannot sit up by themselves (up to 9 months / 9kg approximately). The cradle features hanging toys for your child’s entertainment, and a soothing vibration unit. Warning! - Do not use once baby starts to sit up unaided, and never pick the cradle up by the toybar.
  • Page 3: Preparation For Use

    preparation for use Note: If you wish to use the vibration feature right away, please install the batteries in accordance with section 6 prior to assembly. Pull bar (A) right around until it locks into place against the hinges. Next, lower the footrest frame. When fully open, the frame will look as shown in diagram 2 below.
  • Page 4 preparation for use attaching the toybar When attaching the toybar to the cradle, ensure the toybar frame points upwards (not forwards), and fit the clips to the frame just above the plastic hinges. head support cushion The head cushion is provided to give support to your child's head while using the bouncing cradle.
  • Page 5 in use the harness To secure your child in the harness, place the crotch strap between their legs and insert the harness prongs into the buckle, making sure the child's fingers are clear. Adjust the strap adjuster (A) to get a snug fit around your child.
  • Page 6 the vibration feature The vibration unit should be fitted with batteries before use (refer to section 6, battery installation & replacement). Switch the vibration unit on by sliding the switch to "HI" or “LO” for the HI HI preferred level of vibration. HI HI Switch the vibration unit off by sliding the switch back to the middle “OFF”...
  • Page 7: Battery Installation And Replacement

    battery installation & replacement A Philips head screwdriver and 2 X "AA” batteries are required ( not included ) Only the recommended batteries or equivalents are to be used. Do not use rechargeable batteries. Lift the footrest up and pull the fabric cover upwards to expose the vibration unit.
  • Page 8: Battery Safety Guidelines

    battery safety guidelines ALWAYS ALWAYS ALWAYS Replace the whole set of Store unused batteries in Take care to fit your batteries batteries at one time, taking their packaging and away correctly, observing the plus care not to mix old and new from metal objects which and minus marks on the battery and vibration unit.
  • Page 9: After Use

    after use The cradle can be folded for storage. First remove the toy bar, then pull the base around to rest against the seat cover. The footrest can also be folded up against the seat.
  • Page 10: Care Of Your Product

    Do not use once the child starts to sit up unaided. Never use the toybar as a carrying handle. Do not use replacement parts or accessories other than those approved by Mothercare as they may make the cradle unsafe.
  • Page 11: Replacement Parts

    The replacement parts listed below are available for your product. In the event that you require any of these parts please contact your local Mothercare store or contact Customer Care on 08453 30 40 30 diagram description Seat cover Head support cushion Toybar &...

Table of Contents