Dimplex DXUF 20TN Operating Instructions Manual page 6

English
2. Installation
ATTENTION!
The fan heater may only be used as shown,
i.e. on a horizontal, even surface. Using it on
deep-pile carpets is not permitted. Minimum
clearance in the air outlet area: 750 mm.
3. Electrical connection
Only connect the device to the AC voltage power sup-
ply according to the type plate.
EN-6
4. Operation
The room temperature is regulated using the continu-
ously adjustable thermostat. If the rotary knob is set to
the lowest setting i.e. to the extreme left, the thermostat
switches the heating device on at an ambient tempera-
ture of approx. 5°C.
Using the operating mode rotary knob, two heating lev-
els and a cold air level can be selected.
In the cold air fan operation, turn the thermostat rotary
knob to the right stop.
5. Overload protector
For your safety, the device is equipped with an over-
load protector. If the permissible temperature is ex-
ceeded, the heating device switches off automatically.
When this happens, pull out the mains plug or switch
off the fuse and remove the cause (e.g. when the air
grid is blocked or covered). When the device has
cooled sufficiently, it can be started up again.
If the overload protector is repeatedly triggered, de-
commission the device and contact your electronics re-
tailer.
1805/C
DXUF 20TN
www.dimplex.de/en