Smith & Noble Metro Track Step By Step Installation Instructions

Round wood hardware; wall mount single rod set

Advertisement

Quick Links

STEP BY STEP INSTALLATION INSTRUCTIONS
Metro Track Round
Wood Hardware
Wall Mount
Single Rod Set

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Metro Track and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Smith & Noble Metro Track

  • Page 1 STEP BY STEP INSTALLATION INSTRUCTIONS Metro Track Round Wood Hardware Wall Mount Single Rod Set...
  • Page 2: Table Of Contents

    Everything Table of Contents You Need Getting Started ........3 Step 1 - Overview - Wall Mount Single Rod Set .
  • Page 3: Step 1 - Getting Started

    STEP 1 - GETTING STARTED OVERVIEW Metro Track Round Wood Single Rod Set Tools & Parts Before you begin, check the accompanying diagram to make sure you have all the parts you need. You’ll need to make sure the surface you intend to install your hardware is sturdy enough to accommodate the brackets.
  • Page 4: Step 2 - Mounting The Brackets

    STEP 2 - MOUNTING BRACKETS STEP 2 - MOUNTING BRACKETS Place center of bracket cover plate Place the panel on the rod. To ensure FIGURE A level against wall at the marked spots. it drapes at the correct length, hold Using a pencil, lightly draw a circle it up to the spot you wish to install around the base of the bracket onto...
  • Page 5: Step 3 - Attaching The Rod Connector

    STEP 3 - ATTACHING THE ROD CONNECTOR STEP 4 - PLACING CARRIERS & END STOPS Depending on your order, you may Adding or Removing have received a rod connector. Carriers to the Rod A rod connector is the short piece of CARRIERS Your track rod will come with all ROD CONNECTOR...
  • Page 6: Step 5 - Attaching Bracket To The Rod

    STEP 5 - ATTACHING THE BRACKET TO THE ROD STEP 6 - ATTACH FINIALS Slide rod through bracket posts. Slide End Cap onto rod and tighten set screw. Do not tighten at this time. END CAP FINIALS MOUNTING Attach End Cap Finial. POST (go to step 6) CHANNEL...
  • Page 7: Step 7 - Attaching Bracket Posts To Bracket Bases

    STEP 7 - ATTACHING BRACKET POSTS TO BRACKET BASES STEP 8 - ATTACHING DRAPERY TO ROD Align the mounting posts in the back Insert drapery pin hooks into carriers of the track with the brackets mounted and master carriers. MOUNTING POST to the wall.
  • Page 8: Care & Cleaning

    ACCESSORIES CARE & CLEANING Baton/Wand (optional) Minimal care and cleaning is needed to maintain the beauty of your Hardware. To Vacuum: Use brush or dust head attachment. Baton/Wand will be pre-attached to the master carrier(s). To Dust: Use soft, clean cloth. CLIP BATON/ WAND...
  • Page 9: Warranty

    Warranty Service The enjoyment of your hardware should be everlasting, which is why our products come with a limited lifetime warranty. The warranty applies to the original owner, requires a proof of purchase (hang on to your receipt!) and covers defects in material or craftsmanship. Hardware must have been properly installed.

Table of Contents