kenall LOW PROFILE SCONCE LPS SERIES Installation Instructions

LOW PROFILE SCONCE
LPS SERIES – SEMI-RECESSED MOUNT – REMODEL CONSTRUCTION
INSTALLATION INSTRUCTIONS

1. Back out screw(s) at bottom or side of housing

until baseplate can be easily removed.
Screw

3. Cut a rectangular hole on the wall

(recommended hole size 3-3/8" × 9").
9.000
Cutout
www.kenall.com | P: 800-4-Kenall | F: 262-891-9701 | 10200 55th Street Kenosha, Wisconsin 53144, USA
This product complies with the Buy American Act: manufactured in the United Stateswith more than 50% of the component cost of US origin It may be covered by patents
found at www.kenall.com/patents. Content of speci cation sheets is subject to change; please consult www.kenall.com for current product details. ©2019 Kenall Mfg. Co.
™
Back-box
Wall
3.375
INSTALLATION INSTRUCTIONS

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety precautions
should always be followed, including the following:
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE
APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH
THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND
THE HAZARDS INVOLVED. DISCONNECT POWER TO ALL CIRCUITS
BEFORE WIRING FIXTURE. INSTALL IN ACCORDANCE WITH
ALL NATIONAL, STATE, AND LOCAL CODES. DO NOT CONNECT
TO AN UNGROUNDED SUPPLY. READ ALL FIXTURE MARKINGS
AND LABELS TO ENSURE CORRECT INSTALLATION OF FIXTURE.
SUPPLEMENTAL INSTRUCTIONS MAY BE LOCATED ON THE
FIXTURE, IN ADDITION TO THIS INSTRUCTION SHEET, REGARDING
ORIENTATION, OR MOUNTING RESTRICTIONS.
SAVE THESE INSTRUCTIONS

2. Remove back-box.

4. Drill four (4) 5/16" holes. Use the back-box as a
template to mark pilot holes.
5/16" Dia.
1
Back-box
Wall
2.000
9.750
LPS_F-5295_090418