Instruction On Control Panel Functions - Sharp ES-M1108T Operation Manual

Instruction on control panel functions

Control panel / Display
Plug the machine in and then press this key, the machine
POWER
turns on. Press this key again, it turns off.
Caution 1.If the machine is energized but not started, the power supply turns
off automatically 5 min later.
2.If no key pressed after the START/PAUSE key is pressed during the
running, the power supply turns off automatically 10 min later.
Press this key after turning on, selected course is started.
START/PAUSE
Press this key again, the running is paused. Press it once again,
the running restarts.
Wash daily clothing like relatively-dirty shirts or pants.
NORMAL
Wash heavy and very dirty clothing.
JEANS
Wash speedy for Not-so-dirty clothing.
SPEEDY
DELICATE Wash clothing with the HAND WASH mark.
BLANKET Wash strong for blankets or heavy clothing.
BABYCARE Wash gently and rinse thoroughly for baby clothing.
TUB CLEAN Course for cleaning washing / spin drying tub.
Select the washing time: 2 hrs, 6 hrs, 9 hrs.
Water is saved by 1 time static rinse.
ECO
Select WASH as necessary. Select the washing time: [ - ](= 0 min) ,
WASH
1 min – 15 min.
RINSE Select RINSE as necessary. Select the rinsing time: [ - ](= 0 min) ,
1 time – 3 times.
SPIN
Select SPIN as necessary. Select the spinning time: [ - ](= 0 min) ,
1 min – 9 min.
Course for reducing the time to dry.
AIR DRY
Spin-drying with high-speed takes air into the inner tub from
the hole of top lid.
AIR DRY course reduce the time to dry in the shade greatly.
Select the time: [ - ](= 0 min) , 30 min, 60 min, 90 min.
Select the appropriate water level depending on course or kinds
WATER LEVEL
of clothing. (Select from 8 steps regulation)
6
Common non-fault phenomenon (Please refer to
this section if you think an abnormality happens.)
Abnormal display
Caution
It generates a beep when washing machine indicates abnormal display. If not connec-
ted in 10 min, it turns off automatically.
Because the phenomenon may not be a fault, please check it again before sending
the machine for repair. In the case of failure, please consult the maintenance depart-
-ment. Be sure not to disassemble and repair the machine without permission.
Present-
Possible non-fault
Coping process
-ation
cause
Inclease water supply,
press START / PAUSE
Low flow at the
key.
faucet.
Turn the faucet on,
E1
The faucet is closed.
press START/PAUSE
key.
Water inlet filter net
Clean filter net, press
is blocked.
START/PAUSE key.
Top cover is opened
as the reservation
course starts.
Close top cover.
Top cover is not clo-
E2
-sed during spin
drying.
The drain position is
Adjust drain hose pro-
relatively high.
-perly, press START
/PAUSE key.
The end of drain
E3
hose is blocked.
Clean drain hose,
press START/PAUSE
Drain hose is folded/
key.
crumpled/tied.
Washing machine place
Washing machine
the horizontally with
inclines or is shaky.
E4
adjusting the foots.
The clothing is
Distribute the clothing
lopsided.
evenly.
Pull out the plug from
Water level sensor
the plug seat, and ent-
C2
shows an abnormal
-rust the maintenance
level.
department.
Turn the power off, and
take it from the top.
Top cover opened
Caution
U9
in the situation of
CHILD LOCK is not re-
CHILD LOCK.
-leased, unless you re-
set it manually.
Failure
List of failure cause
cause
Get water in tube of
water level sensor
Circuit failure
Failure of water inlet
valve
Wiring disconnection
Connector contact
failure
Failure of water level
sensor
Failure of safety switch
Failure of drain valve
Failure of drain valve
motor
Connect failure on
drain valve motor
15