Power Switch; Power Out Connector - Bryston PS3 Owner's Manual

Front and Rear Panels

1. Power Switch

Press switch in to apply power to the circuitry.
Press again for switch to move out and remove
power from the supply circuitry.
2. Power LED
The LED lights green (optionally blue) when the
PS3 is powered on.
3. 12V Trigger: Unmute
When an attached compatible preamp is muted,
the PS3 can trigger connected equipment off.
See "External Trigger" on page 5 for more
detail.
4. 12V Trigger: PS3 ON
Trigger attached equipment on or off when
the front panel power switch is pressed by
connecting. See "External Trigger" on page 5
for more detail.

5. Power Out Connector

Connect compatible Bryston equipment to this
port with the cable provided with the partner
equipment. Pin out is as follows
1. +30V / 50mA
2. Mute
3. Ground
1
4. Chassis
5
6 2
5. -30V / 50mA
3
4
6. +12V / 100mA
6
PS-3 DC POWER SUPPLY
12V TRIGGERS
UNMUTE
1 2
6. AC Power Inlet
Connect the PS3 to your AC Mains power using
the provided IEC-320 C13 power cable. Check
the Data Plate located on the bottom of the
unit to ensure that the PS3 is configured for AC
power in your locality.
7. Data Plate
PS3-SIL-120
~120V 60Hz 13W
Serial No:
Date: 1530
number, and date code. Ensure that the voltage
and line frequency conform to your locality
before powering the unit on.
Dimensions
OUTPUT
1
5
6 2
3
4
PS3 ON
FOR COMPATIBLE BRYSTON PRODUCTS ONLY
3 4 5
The data plate is
located underneath the
unit and lists the model
PS3-00000
REV: 1234
number, voltage
requirements, serial
5.7 in. 14.5 cm
8.25 in. 21 cm
POWER INLET
6 7