1. Manuals
  2. Brands
  3. Effective Solutions Manuals
  4. Disc Duplicator
  5. ERS
  6. User manual

Effective Solutions ERS User Manual

Barcode duplicator
Hide thumbs
1
2
3
4
5
6
7
Table of Contents

Advertisement

Quick Links

Download this manual
1.0
1.1
2.0
2.1
2.2
3.0
3.1
3.2
3.3
Appendix A
ERS BARCODE DUPLICATOR
User Guide
CONTENTS
A TYPICAL DUPLICATOR 'KEYPAD'

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ERS and is the answer not in the manual?

Questions and answers

Summary of Contents for Effective Solutions ERS

  • Page 1 ERS BARCODE DUPLICATOR User Guide CONTENTS INTRODUCTION What’s in the box ? INSTALLING THE DUPLICATOR Installing the Standard Duplicator Installing the Telepen Duplicator USING THE DUPLICATOR Reproducing an Existing Barcode Reprinting an Unreadable Barcode Printing Sequentially Numbered Barcode Labels Appendix A...

  • Page 2: Introduction

    1.0 INTRODUCTION This User Guide describes the installation and operation of the ‘generic’ Barcode Duplicator system from ERS. Duplicator functionality may include: - Reproduction of existing (readable) barcodes - Reprinting of existing (un-readable) barcodes - Printing of sequentially numbered barcode labels The actual functionality provided by specific or bespoke versions of the Duplicator may differ.

  • Page 3: Installing The Duplicator

    2.0 INSTALLING THE DUPLICATOR The Duplicator is essentially ready to use ‘out-of-the-box’ simply requiring the labels and ribbon to be installed into the printer, the connection of the scanner and the provision of mains power. Refer to Sections 2.1 and 2.2 below for installation instructions. 2.1 Installing the Standard Duplicator To install the Duplicator (See Schematic diagram 2.1 below): Connect the power cord from the printer PSU to the power socket on the rear...

  • Page 4: Installing The Telepen Duplicator

    2.2 Installing the Telepen Duplicator To install the Duplicator (See Schematic diagram 2.2 below): Connect the printer mains lead to a suitable grounded power outlet. • Connect the scanner to the 25-pin D-type connector located on the rear panel • of the printer Connect the power jack of the scanner PSU to the power socket on the •...

  • Page 5: Using The Duplicator

    3.0 USING THE DUPLICATOR This section describes the use of the Duplicator, including the reproduction of exist- ing barcode labels and the printing of sequentially numbered barcode labels (where implemented). 3.1 Reproducing an Existing Barcode This section describes the procedure to reproduce an existing barcode label which is readable with the Duplicator scanner.

  • Page 6: Printing Sequentially Numbered Barcode Labels

    3.3 Printing Sequentially Numbered Barcode Labels The Duplicator may also provide the facility to print batches of sequentially numbered barcode labels. Where implemented this facility may be used as follows: 1) Scan the required quantity of labels from the Quantity Pad section of the Duplicator Keypad 2) Enter the ‘start’...
  • Page 7 APPENDIX A A TYPICAL BARCODED DUPLICATOR KEYPAD The barcode Duplicator will normally be supplied with an A4 sized barcoded ‘keypad’ for use when re-printing unreadable barcode labels or when printing batches of sequentially numbered labels. The detailed format of the Keypad supplied with each Duplicator may vary slightly depending on the specific requirements of that Duplicator, however in general a Duplicator Keypad may include up to 3 sections as follows: - A ’Number’...

Table of Contents