Advertisement
Sailrite Blade Foam Saw User Guide
CHANGING THE BLADE
To test the sharpness of your blades, with the saw turned off, run your fingers across the point of the teeth at the top and bottom of the
blades and compare. The upper teeth do very little cutting and will be sharper than the bottom teeth. If the bottom teeth feel too dull,
then you can replace the cutting blade.
1. To replace the moving blade, stop the tool with the blade in the "up" position, exposing about ½ inch of blade at the top of its blade
guide. Then unplug the tool.
2. Using the included Allen wrench, loosen the set screws on the block at the top of the blades.
3. To remove the moving blade carefully slide the blade up and then lift it out.
4. Take the new blade and position it so the side with the cutout is facing the bottom of the tool. Carefully slide the blade into the blade
guard from the top to the bottom. Push the blade back into the guard and then slide it all the way up into the sliver locking block at
the top of the tool.
5. Tighten the set screws.
LUBRICATION
For general maintenance of your foam cutter, the moving blade should be occasionally lubricated with any lubricating oil. This reduces
heat and friction on both sides of the moving blade and prolongs the life of the motor.
1. Stop the motor so that the moving blade is in the "up" position, exposing about ½ inch of blade at the top of its blade guide.
2. Apply the lubricant to both sides of the moving blade, the top of the blade guide. The up and down motion of the blade will then
distribute the oil onto the blade guide on either side of the blade.
WARRANTY
Sailrite warrants this foam cutter (with exception of the blades) for a period of one year starting from the date of sale against defects in
material and workmanship. This warranty is voided by improper use, disassembly, repair or alteration by owner or unauthorized parties.
SPECIFICATIONS
#121244
Volts
110V AC
Amps
5.0A
Variable Speed
Yes
Stroke
15mm
Max. Cutting Height
7.5"
Sailrite Enterprises, Inc.
2390 East 100 South, Columbia City, IN 46725
Phone (800) 348-2769 / (260) 244-4647
Fax
(260) 818-2005
Email info@sailrite.com
Sailrite.com
© 2018 Sailrite Enterprises, Inc.
#121294
Volts
220-240V AC
Amps
5.0A
Variable Speed
Yes
Stroke
15mm
Max. Cutting Height
7.5"
2
Advertisement
