Table of Contents
Advertisement
THANK YOU!
We are grateful you have chosen FM VHF/UHF portable transceiver.
This 2-way radio represents novel design and stable performance. It
is developed to meet the demands of portability, easy-operating and
multifunction. Believes the small size and the reasonable price will
satisfy your requirements.
I
Advertisement
Table of Contents
Summary of Contents for Zastone T30
- Page 1 THANK YOU! We are grateful you have chosen FM VHF/UHF portable transceiver. This 2-way radio represents novel design and stable performance. It is developed to meet the demands of portability, easy-operating and multifunction. Believes the small size and the reasonable price will satisfy your requirements.
-
Page 2: Safety Information
SAFETY INFORMATION SAFETY It is important for you to read the following carefully in order to use this transceiver safely and effi ciently. Please DO NOT try to open the transceiver. Modifi ed by laypeople may do damage the transceiver. ... - Page 3 CHECKING EQUIPMENT Thank you for using T30 transceiver. Before using, we recommend you: Please check whether the package is broken. Unpack the transceiver carefully: Identify the items listed in the following table. If any damage or miss has occurred during shipment, contact with dealer immediately.
- Page 4 MAIN FUNCTION VHF Frequency Range: 136MHz -173.995MHz UHF Frequency Range: 400MHz~479.995MHz 16 Stored Channels CTCSS Alarming Function PC program Wire Copy Function Chinese/English Channel Number Voice Annunciation...
-
Page 5: Table Of Contents
CONTENTS GETTING ACQUAINTED .............. 1 PREPARATION ................3 Charging Battery Pack ............. 3 Installing/Removing Battery Pack ..........4 Installing the Belt Clip .............. 4 Power ON/OFF ................. 5 Adjust Volume ................5 Frequency Select ..............5 Transmit/Receive ..............5 BASIC OPERATION ..............5 CHANNEL EDIT ................ -
Page 6: Getting Acquainted
GETTING ACQUAINTED Antenna Power/Volume Transmitting/ Knob Receive Indicator Speaker Microphone Earphone PTT Transmit Slot/PC Program Slot Firce to Receive(MONI) Battery Pack Alarm Knob... -
Page 7: Li-Ion Battery
Rubber antenna used to receive and Antenna transmit signals. Transmitting Indicator Lights red while transmitting. Receive Indicator Lights green while receive. Turn clockwise until a clatter to switch on the transceiver. Turn Power/Volume Knob counterclockwise until a clatter to switch off the transceiver; Rotate to adjust the volume. -
Page 8: Preparation
PREPARATION CHARGING BATTERY PACK The battery is not charged in the factory, and please charges it be- fore using. The fi rst charging can’t reach full capability after buying or storing for a long time (more than two months). Please charge and discharge it for two or three times to make real capability reach full capability. -
Page 9: Installing/Removing Battery Pack
INSTALLING/REMOVING BATTERY PACK Match two juts on the top and two grooves at the bottom of the battery pack with the corresponding guides on the aluminous frame on the back of the transceiver. Slide the battery pack upon until hearing a clatter. Please turn off the transceiver fi... -
Page 10: Power On/Off
BASIC OPERATION POWER ON/OFF Turn the Power/Volume knob clockwise to switch on the transceiver, you will hear a beep. Turn the Power/Volume knob counterclockwise to switch off the transceiver. ADJUST VOLUME Turn the Power/Volume knob clockwise to increase volume, and turn it counterclockwise to decrease volume. -
Page 11: Channel Edit
CHANNEL EDIT PC Program: Connect the program cable to the radio, and well connect the com- puter COM (communication port) and SP/MIC jack by program cable, turn on the radio at the same time. Turn on the computer, and open the radio program soft. Then se- lect the using frequency and other function parameters which you re- quired, Afterward, press the [ Edit ] [ write to radio ], or directly press the relative signal on the toolbar to start writing. - Page 12 While copy data, if the indicator fl ash unnormal, it means copy failed, please check whether connect the wire well, while the copied radio is light on, press [MONI] button again. If you want to copy many radios, please turn off the copying radio’s power, and cut off the wire, then change to connect an- other copying radio, and press [MONI] button of copied radio to start copy.
-
Page 13: Transmitting Time-Out-Timer
AUXILIARY FEATURES TRANSMITTING TIME-OUT-TIMER The purpose of the Transmitting time-out-timer is to prevent any sin- gle person from using one channel to transmit for an extended period of time. BATTERY SAVING Battery saving makes the transceiver cut down receiving circuit to decrease power consumption and longer use time when these is no signal. -
Page 14: Specification
SPECIFICATION General Part UHF: 36~173.995MHz Frequency Range VHF: 400~479.995MHz Temperature Range -10°C+60°C Frequency Combination Phase lock loop frequency synthesize Rated Voltage DC7.4V (Li-ion battery) Stored Channel 16 channels Antenna Rubber antenna Antenna Impedance 50 Simplex of co-frequency or alien fre- Operation Mode quency Dimension... - Page 15 Receive Part Sensitivity <0.16uV(12dB SINAD) Squelch Sensitivity 0.12uV 500mW Audio Power 150mA Receive Current Squelch System Waiting Current 20mA NOTICE: Saving your presence, no additional notice will be send if specifi cation changes because of technology-improving.
-
Page 16: Common Error And Solution
COMMON ERROR AND SOLUTION Error Solution Battery power used up, please change the battery or recharging. On feedback when turn on the radio Wrong connect of battery, please remove the battery and reinstall it. The power of bat- The battery life is ended, please use new tery easily get lost battery. -
Page 17: Frequency/Information List
FREQUENCY/INFORMATION LIST Model No.:_________________________________________________ Serial No.: _________________________________________________ Transmit Receive Channel CTCSS Frequency Frequency...