Table of Contents
Advertisement
Introduction
Congratulations on choosing the Royal Easi-Move travel trailer manoeuvring system. This has been produced
according to very high standards and has undergone careful quality control procedures.
Simply by using the remote control handset you can move your trailer effortlessly into any position required
within operating guidelines. Soft start and soft stop technology allows you to manoeuvre your trailer even more
accurately without any sudden starts or stops.
Before proceeding with installation and starting to use the manoeuvring system, please read this manual very
carefully and be aware of all the safety instructions! The owner of the travel trailer will always be responsible
for correct use. Keep this manual inside your travel trailer for future reference.
The Easi-Move V4 manoeuvring system consists of four 12V motor-power rollers, two 12V electronic control
units and a remote control handset. To function, the motor-powered rollers must be engaged against the tires
of your travel trailer. The supplied cross actuation device enables you to engage both rollers at the same time
from one side of your trailer. Once this is done the manoeuvring system is ready for operation. The remote
control will allow you to move your trailer in the required direction.
Intended Use
The Royal Easi-Move V4 manoeuvring system is only suitable for single or tandem axle trailer's up to 7750 lbs.
Depending on the weight of the trailer, the manoeuvring system cannot overcome obstructions that are more
than aproximately 1½ " in height without assistance (please use wedges as a ramp).
Specifications
Specifications
Designation
Operational Voltage
Average Current Consumption
Maximum Current Consumption
Speed
Weight
Permissible Overall Weight
Permissible Overall Weight on
Minimum Width (trailer)
Maximum Width (trailer)
Maximum Tyre Width
Power Source (deep cycle battery)
Installation Safety Guidelines
Read this User Manual carefully before installation and use. Failure to comply with these
rules could result in serious injury or damage to property.
These symbols identify important safety precautions. They mean CAUTION! WARNING!
SAFETY FIRST! IMPORTANT INFORMATION!
Before starting installation under the trailer:
Check the towing load of your vehicle and the gross weight of your trailer in order to establish whether they are
designed for the additional weight. The manoeuvring system itself has a weight of about 162 lbs.
Check that the trailer is disconnected from the battery supply and the mains electrical supply.
Only use adapters and accessories that are supplied or recommended by the manufacturer.
Check that the tires are not over worn and have the same size and design.
Make sure that the tire-pressures are correct to the manufacturer's recommendation.
Make sure the chassis is in good condition without any damage and is free from rust, dirt etc.
Stop work immediately if you are in doubt about the assembly or any procedures and consult one of our
engineers (Please refer to contact information on the last page of this manual).
Royal Easi-Move V4
12 Volt DC
20 Ampere
100 Ampere
approx.13cm per sec.
approx.
7750 lbs
15%
Gradient
5500
71"
99"
8"
12V 105Ah (recommended), 12V 85Ah (minimum) 2sets
or 12V 200Ah (recommended), 12V 150Ah (minimum)
page
176 lbs(exclusive of battery)
lbs
3
Advertisement
Table of Contents
