Summary of Contents for Orange Electronic M207
- Page 1 Orange Electronic Co., Ltd. | 04-2560-2766 | www.orange-electronic.com M207 User Manual To ensure correct operation and service，read the following instructions before operating the Motorcycle TPMS accessory. 1/13...
- Page 2 Orange Electronic Co., Ltd. | 04-2560-2766 | www.orange-electronic.com TPMS Tire Pressure Monitoring Systems (TPMS) improves safety while driving. Once installed in your vehicle, the system will automatically monitor your tires in real-time for pressure and temperature. When any tire’s pressure and/or temperature appear abnormal, the system will, in real-time, transmit signals to active an alarm and show a digital figure to warn the driver of a problem.
-
Page 3: Specification
Orange Electronic Co., Ltd. | 04-2560-2766 | www.orange-electronic.com Suggestion: Please check valve stem every year to be sure the valve stem is not leaking air. Reacting to Alerts When an alert or warning is received, reduce vehicle’s speed and proceed to a safe location to stop where the tire can be inspected and /or serviced. - Page 4 Orange Electronic Co., Ltd. | 04-2560-2766 | www.orange-electronic.com ACCESSORIES Item Display unit Ⅰ、Sensor Ⅱ、Valve stem Ⅲ、Grommet Ⅳ、Nut Ⅴ、Screw Velcro for Display Ties for power cord Clip Orange display bracket M207 Ⅱ Ⅴ Ⅰ Ⅲ Ⅳ 4/13...
-
Page 5: System Installation
Orange Electronic Co., Ltd. | 04-2560-2766 | www.orange-electronic.com SYSTEM INSTALLATION The Orange Electronic Motorcycle TPMS Kit requires both the display unit and tire sensors to be installed. It is recommended to install the display unit before the two sensors. DISPLAY UNIT INSTALLATION... -
Page 6: System Operation
Orange Electronic Co., Ltd. | 04-2560-2766 | www.orange-electronic.com SENSOR INSTALLATION NOTICE SAFE 1. Valve stem aims vertically to sensor. 2. Use a torque wrench and make sure to tighten the hexagonal nut to 4.5~5Nm. 3. Make sure sensor doesn’t touch the rim. - Page 7 Orange Electronic Co., Ltd. | 04-2560-2766 | www.orange-electronic.com Once accessory power is applied, the system will scan both tire sensors and display tire pressure and temperature in real time within 3 minutes. (Fig.1) (Fig.2) Use the “Fun” (function) button to...
- Page 8 Orange Electronic Co., Ltd. | 04-2560-2766 | www.orange-electronic.com 3. Once your preferred pressure unit is displayed, press and hold "Set" button for 3 seconds until the temperature unit is displayed. 4. Press the "Set" button to choose Fahrenheit (F) or Celsius (C) 5.
-
Page 9: System Alarm
Orange Electronic Co., Ltd. | 04-2560-2766 | www.orange-electronic.com Preset warning level: 80°C /176 °F Preset warning range: 60~100°C =140~212 °F 1. The display unit will show "Hi" and flashing numbers. 2. Press the "Fun" button to modify flashing numbers to desired high temperature warning level. -
Page 10: Sensor Replacement
Orange Electronic Co., Ltd. | 04-2560-2766 | www.orange-electronic.com SENSOR REPLACEMENT If a new sensor is replaced or if tires are rotated, the sensors need to be relearned by the display unit in order to display the correct information. Step Install a new Orange sensor according to directions (page 5). -
Page 11: Warranty Policy
°F WARRANTY POLICY Orange Electronic products are guaranteed from material defects for 365 days after the date of purchase. If the product fails under normal circumstances within the 1st year, Orange Electronic will repair or replace the product. Product will not be replaced or repaired if damaged from misuse or incorrect application. -
Page 12: Troubleshooting Guide
Orange Electronic Co., Ltd. | 04-2560-2766 | www.orange-electronic.com Cannot use other brands’ TPMS sensors for replacement parts. Using other brands will cause failure reception and invalid warranty. Any questions pertaining to warranty information or other questions not answered in the preceding pages can be answered by the place of purchase or by Orange Electronic service phone line or e-mail address: E-mail：sales@orange-electronic.com... - Page 13 Orange Electronic Co., Ltd. | 04-2560-2766 | www.orange-electronic.com Solution：Send the defected receiver display back to agent for repair and reconfigure its ID by following “SENSOR REPLACEMENT” setting E. The pressure (or temperature) values show the wrong tire locations 1. The IDs of the two tires are not configures correctly Solution：...