Honda Z125MA Manual page 98

20180319161948_32K0FE000_eng_BOOK Page 98 Monday, March 19 2018 16:27:28 JST
NOTICE
When installing a wheel or caliper into original
position, carefully fit the brake disc between the
pads to avoid scratching them.
Make sure that the lug on the swingarm is
2.
positioned in the slot on the brake caliper
bracket.
Brake caliper bracket
Adjust the drive chain slack.
3.
Install and tighten the rear axle nut.
4.
Torque: 59 N·m (6.0 kgf·m, 44 lbf·ft)
After installing the wheel, apply the brake
5.
pedal several times, then check if the
wheel rotates freely. Recheck the wheel if
the brake drags or if the wheel does not
rotate freely.
Slot
If a torque wrench was not used for
installation, see your dealer as soon as
possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.
Lug
Swingarm
Tyre Puncture Removing Wheels
u
P. 74
2
95