CSN Turbo-Tech CIRC-3 Installation Instructions Manual

Turbo-Tech CIRC-3 Pump & Bridge Control
When installing and using this electrical equipment, basic safety precautions must be
followed.
1. READ AND FOLLOW ALL INSTRUCTIONS.
2. WARNING - To reduce the risk of injury, do not permit children to use this equipment unless they
are closely supervised at all times. This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities, or lack of experience or knowledge,
unless they have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety. In order to avoid the possibility of hyperthermia (heat stress) occurring, it
is recommended that the average temperature of spa pool water should not exceed 40 degrees C.
3. CAUTION – Connect only to a circuit protected by a Class A Safety Switch. This equipment shall be
located out of reach of a person in the tub.
4. FOR SPA & HOT TUB USE ONLY – This equipment was specifically designed for use on spas
and hot tubs only in conjunction with an approved spa control system. For other applications consult
the manufacturer.
5. WARNING: Risk of Electric Shock. (For Spa & Hot Tub Use)
Ensure this equipment is installed out of reach of persons in the spa or hot tub. For safety, this
equipment is intended to be installed in an enclosure that requires the use of a tool to gain access to
the equipment. Also ensure the equipment is adequately fixed into position. Install in accordance
with these installation instructions and wiring diagram.
6. SAVE THESE INSTRUCTIONS.
To reduce the potential risk of fire, electrical shock, or injury to persons:
1. All electrical wiring (both installation & repair) must be done by a licensed electrician and in
accordance with local, provincial, and national ordinances.
2. No modifications, additions or deletions should be made to this equipment.
3. When servicing, be sure the power is off before accessing this equipment.
4. Do not use cables or connections other than the ones supplied with this equipment. If the supply cord
is damaged, it shall be replaced by the manufacturer or its service agent or similarly qualified person
in order to avoid a hazard.

CIRC-3 VARIABLE SPEED PUMP INSTALLATION

GENERAL

Your TURBO-TECH CIRC-3 pump has been quality built and engineered to give maximum energy efficiency under
normal spa water pumping conditions. Consult the manufacturer for any other applications.

LOCATION OF PUMP

For the best pump performance, locate the system as close to the water source as possible, preferably in a dry
position lower than the spa water level. Make sure the pump has adequate ventilation, is well fixed at the base plate
provided and is not accessible to persons whilst in the spa. Provide adequate access around the pump for inspection
and maintenance.

PLUMBING CONNECTIONS

Fit the pump to your plumbing scheme using the 40mm (1.5") Quick Connect Unions provided. Ensure Union
O'Rings are clean. Lube with silicon based lubes only (DO NOT USE PETROLEUM BASED LUBRICANTS). Hand
tighten Unions only. Do not over tighten.
STARTING & PRIMING PUMP
Do not run unit dry. Always be certain that the pump casing is filled with water before starting the unit. Allow a
reasonable amount of time for priming. If the pump will not start or will not prime, see troubleshooting section in this
manual.
Installation & Instruction
Manual

IMPORTANT SAFETY INSTRUCTIONS

CAUTION
www.csnglobal.com.au