KLIK LEDpod 40 Installation Instructions

KLIK LEDpod™ 40 Installation Instructions
Ø 0.98"
1.18"
Ø 1.02"
Aprx 2"
Pull a loop of wire through hole.
3
90°
Fit clip into place until the clamping
6
ends are equally centered over the
hole. Use the tool to center the clip until
equal pressure can be felt and inspect
by eye.
Light
The notch indicates
the direction of the light,
direction
Asymmetrical LEDPods
Push LEDPOD in until it snaps into place
9
and the outer surface is flush with the
outer surface of the tube.
Prod the rim of the clear silicone IP Seal
to provide a tighter fit.
www.klikusa.com - sales@klikusa.com
Ø 25 ± 0.2mm
Use a 25mm annular
cutter to bore hole.
(Use 1" in aluminum.)
Rotate retaining clips in as shown. Avoid
4
tangling or severing through wire.
Install Scotchlok connectors to the (0.75-1.5sq)
7
red and black wires. Connect the corresponding
color wires of the driver to the Scotchloks and
assure the clip is secured.
LEDPOD Removal Steps
Insert removal tool into the
1
2mm holes in the LEDPOD.
With firm pressure, rotate
the LEDPod 90°.
OD 1.50"
1.66"
Make sure drilled holes are
1
deburred and excess swarf
is removed from railing.
Thru.
wire
Apply pressure as shown to deform clip into place in a
5
circular motion. Avoid damaging the surface of tube
and tangling or severing through wire.
POSITIVE [ + ]: Red
NEGATIVE [ - ]: Black
8
Carefully peel back
2
the IP silicone seal
one side at a time.
Be sure to re-attach
the silicone seal ready
for reinsertion.
PAGE 1 OF 2
Feed through appropriate
2
wires (0.75-1.5mm²).
CAREFULLY feed the Scotchloks to the left
of the clip and the driver to the right with the
driver connector hanging out. Ensure wires
are clear from where the LEDPOD is to fit.
Proceed to connect the LEDPOD.
Carefully remove the LEDPOD
3
from the clip, ensuring not to
damage or disconnect wires in
the process.
32863-C.1