Sigma Glow-01 Installation Instructions

Installation Instruction

PLEASE READ ALL INSTRUCTIONS BEFORE ATTEMPTING INSTALLATION
1. To prevent personal injury or product damage only licensed electricians should install.
2. To avoid electrical shock or component damage, disconnect power before attempting installation or servicing.
3. This product must be installed in accordance with the national electric code (NEC) and all applicable federal, state and local electric
codes and safety standards.
4. Disconnect product and allow cooling prior to any further steps.
5. Any alteration or modification of this product is expressly forbidden as it may cause serious personal injury, death, property damage
and/or product malfunction.
6. To prevent product malfunction and/or electrical shock this product must be properly grounded.
7. This luminaire is designed to operate in ambient temperatures ranging from -25° C to 40° C and to be horizontally mounted with the
LED board facing downward.

Surface-mounted with J-BOX

1
. Loosen the screw on the
side of the housing and pull
out the connecting plate

Pendent Installation with 3/4 inch conduit

1
. Loosen the screw on the side of the
housing and pull out the connecting
plate,
2
. Fix the connecting plate
onto the ceiling and put
the wire through center
hole
2
. connect the wires as following shows,
Black
White
Green/Yellow
3
. Buckle the connecting plate
into the clips and connect
the wires as following shows
Black Line
White Neutral
Ground
Green/Yellow
3
. Screw the lamp and conduit pole
together tightly
Line
Neutral
Ground
Parking Garage Fixture
4
. Slide lamp back into the
connecting plate and fix
the screw that is removed
in step one