Ac Power Cord Connections - Sealey SPI3S.V2 Instructions For Use Manual

Intelligent speed charger
Hide thumbs Also See for SPI3S.V2:
Table of Contents

Advertisement

7.
FOLLOW THESE STEPS WHEN BATTERY IS OUTSIDE OF THE VEHICLE.
WARNING
WARNING
7.2 Attach at least a 24-inch (61 cm) long 7 AWG (10 mm
NEGATIVE (NEG, N, -) battery post.
7.3 Connect the POSITIVE (RED) charger connector to the POSITIVE (POS, P, +) post of the
battery.
7.4 Position yourself and the free end of the cable you previously attached to the NEGATIVE
(NEG, N, -) battery post as far away from the battery as possible – then connect the
NEGATIVE (BLACK) charger connector to the free end of the cable.
7.5 Do not face the battery when making the final connection.
7.6 Connect charger AC supply cord to electrical outlet.
7.7 When disconnecting the charger, always do so in the reverse order of the connecting
procedure and break the first connection while as far away from the battery as practical.
7.8 A marine (boat) battery must be removed and charged on shore. To charge it onboard
requires equipment specially designed for marine use.

8. AC POWER CORD CONNECTIONS

WARNING
WARNING
does not fit the outlet, have a proper outlet installed by a qualified electrician. An improper
connection can result in a risk of an electric shock or electrocution.
8.3 Recommended minimum AWG size for extension cord:
• 100 feet (30.5 meters) long or less – use an 18 gauge (1.0 mm
• Over 100 feet (30.5 meters) long – use a 16 gauge (1.25 mm
9. FEATURES
1
2
10. ASSEMBLY INSTRUCTIONS
10.1 Remove all cord wraps and uncoil the cables prior to using the battery charger.
11. CONTROL PANEL
DIGITAL DISPLAY
The digital display indicates the status of the battery and charger. See Display Messages
for a complete list of messages.
A SPARK NEAR THE BATTERY MAY CAUSE A
WARNING
BATTERY EXPLOSION. TO REDUCE THE RISK OF
A SPARK NEAR THE BATTERY:
7.1 Check the polarity of the battery posts. The
POSITIVE (POS, P, +) battery post usually has a larger
diameter than the NEGATIVE (NEG, N, -) post.
RISK OF ELECTRIC SHOCK OR FIRE.
8.1 This battery charger is for use on a nominal 230V, 50Hz circuit.
The plug must be plugged into an outlet that is properly installed in
accordance with all local codes and ordinances. The plug pins must
fit the receptacle (outlet).
DANGER
8.2
5
1. AC Power cord
2. Digital display
3
3. Battery type/
4
4. LED indicator
5. Hook attachment
6. Battery clamps
7. Ring terminals
6
) insulated battery cable to the
2
Never alter the AC cord or plug provided – if it
language button
(quick-connect)
(quick-connect)
6
) extension cord.
2
) extension cord.
2
7

Advertisement

Table of Contents
loading

Table of Contents