Renkforce D-3000 Operating Instructions Manual page 27

Example:
DIP switches 1, 3 and 5 are set to "ON", all other switches are set to "OFF".
DMX channel = 1 + 4 + 16 = 21
• The amount of fog is smoothly adjusted via the DMX value of the set DMX channel.
Value "0" no fog output
Value "255" maximum fog output
If no fog emerges or if the fog burst is interrupted, heating has not been completed, or the device
is re-heating (display: Warming Up).
Ensure that the tank never runs empty during fog operation. Should this happen nevertheless,
turn the fog machine off immediately using the mains switch POWER (1) and let it cool down.
Refill the tank after cooling. The fill level is evident at the side at the tank fill level display.
Slight fog lag after deactivation/disconnection of a device is normal and does not suggest a
defect.
If you no longer require the device, disconnect the mains plug and let the device cool down.
Then empty the tank. This prevents leaking of fog liquid during transport or storage.
27