Canaropa 1900 Series Installation Instructions

1900 SERIES DOOR CLOSER WITH SLIDE TRACK ARM (SAHO1900/SANHO1900)
PULL SIDE
Spring Power
Adjusting Screw
Right Hand Door - RH
 INSTALLATION INSTRUCTIONS
Use diagram below to locate holes on door and frame:
1 
4 holes on door for door closer
2 holes on frame for track assembly
2 20-5/16 (516)
(51)
5/32" Drill or Drill & Tap 10-32 UNF
3/16" Drill or
Drill & Tap
1/4-20 UNC
2- 15/16
11 - 1/8
(75)
(282.5)
Hold-Open: Slider, Stopper, Side cap in to the track.

2
Non Hold-Open: Slider, Side cap in to the track.

Side cap
Install the body to the door.

3
Install the track assembly to the frame.
Install main arm to pinion shaft of door closer, see Figure 1.

4
Rotate the main arm and attach to the slider, see Figure 2.

45°
Main Arm
Figure 1
Adjust Hold-Open angle (if applicable)

5
Adjust door closer power and speed as

per door closer instructions
Install cover to the body.

CLOSER ADJUSTMENT
LATCH SWEEP Optional
SPEED SPEED DELAYED ACTION
Installation Instructions
SPRING POWER ADJUSTMENT
1-1/8
29/32
(28.5)
(2 3)
CAUTION
Stopper
(SAHO1900)
DIRECTION
Slider
and
SEQUENCE
Track
Track assembly
Body
45°
Figure 2
FIXING HOLE FOR COVER
Spring Power
Adjusting Screw
*SEE DOOR CLOSER
BACKCHECK
INSTRUCTIONS
CONTROL
FOR DETAILS
STANDARD (120°)
Spring Power
Adjusting Screw
.
4mm Hex key
 INSTALLATION INSTRUCTIONS
Use diagram below to locate holes on door and frame:
1 
4 holes on door for door closer
2 holes on frame for track assembly
2
2
(51)
(51)
29/32
(2 3)
Hold-Open: Slider, Stopper, Side cap in to the track.

2
Non Hold-Open: Slider, Side cap in to the track.

CAUTION
DIRECTION
and
SEQUENCE
Install the body to the door.

3
Install the track assembly to the frame.
Track assembly
Install main arm to pinion shaft of door closer, see Figure 1.

4
Rotate the main arm and attach to the slider, see Figure 2.

45°
Figure 2
Adjust Hold-Open angle (if applicable)

5
Adjust door closer power and speed as

per door closer instructions
Install cover to the body.

Closing cycle
Spring Power
Adjusting Screw
20-5/16 (516)
5/32" Drill or Drill & Tap 10-32 UNF
3/16" Drill or
1-1/8
Drill & Tap
(28.5)
1/4-32 UNC
11 - 1/8
( 282.5 )
Side cap
Stopper
(SAHO1900)
Slider
Track
Body
Opening cycle
Fast
Slow
SA1900-INST-EN-2016/09
PULL SIDE
Left Hand Door - LH
2
(50)
2- 15/16
( 75 )
45°
Main Arm
Figure 1
Decrease
Increase
1/2