Veeder-Root TLS RF Quick Start Up Manual

(iii) Making Electrical Connections
1. Connect Mag-Probe/Mag-Sump-sensor wires to the left con-
nector and battery connections to the right connector.
2. Verify that green LED (Fig.12) flashes every 6 seconds fol-
lowed by the adjacent red LED.
3. Make sure the LED closest to J3 connector in RCVR also
flashes with an interval of 6 seconds or smaller. Make sure
both the RS485 Transmit & Receive LEDs flash.
4. Close the lid.
Make sure the rubber gasket (O-ring) is properly placed
on the inner lining of lid and on screws that secure lid.
Overtightening lid screws may result in plastic damage
resulting in water infiltration.
5. Similarly install all other transmitters.
F. Connect TLS to TLS-RF
1. In this example, device output 1 (Item 1 Fig. 13) is
a Mag probe - Observe polarity.
2. In this example, device output 2 (Item 2) is a Mag
Sump Sensor - Observe polarity.
3. 0.5 inch (12.7mm) i.p.s. conduit (Item 3) to TLS
console.
4. Probe interface module (Item 4) in TLS console.
5. Smart Sensor interface module (Item 5) in TLS con-
sole.
G. Repeater Installation
Install repeater with clear line of sight to maximum number of transmitters as possible. You can give
power to repeater (Item 1 Figs. 14/15) either:
• From Receiver (Item 2 Fig. 14), or
• From a 15V/100mA power adapter (Item 2 Fig. 15)
2
1
+ J4
J4 J3
S2
S2
S1
S3
Fig. 14
H. Installation Verification
Select the Diagnostic Mode in the TLS Console and go to In-Tank Diagnostic Function. Verify that all
Mag probe/Mag Sump Sensor serial numbers correctly match their installed locations.
S1 S2
PWR GND +IN -IN
PROBE
J3
S3
Fig. 12
PROBE 5
PROBE 4
RS-485
PROBE 3
+
PROBE 2
G
15V
PROBE 1
G
15V 2
REPEATER
PROBE / PROBE THERMISTOR
+ 1 + 2 + 3 + 4 1 2
THERMISTOR
PROBE / THERMISTOR INTERFACE MODULE
1 2 3 4 5 6
SMA RT
+ + + + + +
S ENSOR
SMART SENSOR INTERFACE MODULE
Fig. 13
1
J4 J3 +
+
J3
S2
S1
S1
S3
S3
2
Gnd
DC AC
+15 Vdc
Fig. 15
BATTERY
J4
1
3
4
3 4 MAXIMUM PROBE
OUTPUT R ATINGS:
13 VD C
0.2 AMP
7 8
+ + MAXIMUM
OUTPUT R ATINGS
13 VD C
0.2 AMP
5
Manual No: 577013-877• Revision: A
TLS RF Wireless System
Quick Startup Guide
WARNING ALARM
POWER
TLS-300
Monitoring System