Advertisement
Quick Links
OPERATING AND INSTALLATION INSTRUCTIONS
DESCRIPTION:
The iGAZERSR33HD-B is an infrared photo eye used for safety detection in automated gates. The
RX photo eye is hard wired to the gate operator with 12/24 VAC/DC power. The TX photo eye is
battery powered with 4 AAA 1.5 V batteries. The photo eyes are convenietly adjustable - horizontally
+\- 90 degrees and vertically +\- 15 degrees. Due to the sealing gasket within the steel casing, the
photo eye is resistant to the elements at an IP rating on 55.
ASSEMBLY INSTRUCTIONS
Attach the photo eyes approximately 15-24 inches from the ground, and at a maximum distance of
4 inches from the impact zone fo the gate. The photo eyes should be placed close enough to the
gate to detect any obstruction caused at the border of the impact area. In the case of swing gates,
the 4 inch eistance is to be measured with the door in the open position. It is recommended to
install both the transmitting and receiving photo eye on the same axis.
TECHNICAL SPECIFICATIONS:
Power supply
Operating Temperature
RC consumption
TX Battery Type
Battery Life (Low power)
Battery Life (High power)
Range (Low)
Range (High)
Wave length
Modulation
Current commutable by the relay
Rating
Load
GASKET MOUNTING:
Make sure the rubber gasket is placed in the channel
and is flush with the edge of the metal housing. It is
important to ensure the gasket is in place on the back
of the photo eye in order for the housing to be sealed
correctly. Once the gaskets are in place, the housing
can be secured with the screws provided.
V.8.2.17
iGAZERSR33HD-B
Battery Powered
Photo Eyes
12/24 VAC/DC
5° to 140°F
47 mA at 12 VAC; 35 mA (inactive)
22 mA at 12 VDC; 16 mA (inactive)
48 mA at 24 VAC; 36 mA (inactive)
24 mA at 24 VDC; 18 mA (inactive)
6V, 4AAA
24 months
14 months
26 feet
49 feet
950 nm
1.33 KHz
1 A at 24 V
IP 55
33 feet
ATTENTION:
Transmitter Solutions is not responsible for wrong
connections or damages to persons or things. The
installation must be done by qualified people.
Advertisement
Summary of Contents for Transmitter Solutions iGAZE iGAZERSR33HD-B
- Page 1 TECHNICAL SPECIFICATIONS: ATTENTION: Power supply 12/24 VAC/DC Transmitter Solutions is not responsible for wrong Operating Temperature 5° to 140°F connections or damages to persons or things. The RC consumption 47 mA at 12 VAC;...
- Page 2 WARRANTY: The warranty period of this Transmitter Solutions photo eye is 24 months. This warranty shall begin on the date the photo eye is manufactured. During the warranty period, the product will be repaired or replaced (at the sole discretion of Transmitter Solutions) if the product does not operate correctly due to a defective component.