Advertisement
5. PSJ-M3 installation
! PSJ should be installed by specialists only!
Advanced knowledge of AEG replicas is crucial!
Basic knowledge of electronics and soldering skills are needed as well.
Never use soldering gun!
Manufacturer takes no responsibility for damages caused by unprofessional installation!
5.1. Preparation
For PSJ-M3 installation, take gearbox out of your replica, open it and remove all of its content.
Pict.1: Gearbox with all of its content removed
5.2. PSJ-M3 mounting
Insert your unit into gearbox, bottom side first. If it does not fit properly, you need to adjust gearbox. Prepare
gearbox for smooth unit insertion. After your unit is placed, check for any conductive contacts with gearbox. If
there are any, you need to insulate them! You can sharpen your gearbox or you can use some insulation material.
Bottom side of unit is insulated by pre-installed insulation foil. Before final insertion, remove protective foil from
heat-conducting foil. Now you can fix the unit with a screw and organise cables. Never sharpen the unit.
Pict.2: Installed PSJ-M3 gen.2
Advertisement
