Advertisement
WARNING!
After connecting the device to a charger, a periodically blinking yellow diode in the base indicates lack of any programmed remote controls.
The image below shows the components needed to assemble the
whole system.
1) Stand S + DC extension
2) power supply 19V/3.42A
3) charging cable
4) cleaning tissue with isopropoxide
5) smartphone
Optiguard sp. z o.o.
ul. Aleksandrowska 6-10, 87-100 Toruń
NIP 956-213-03-91
Phone +48 56 654 71 33
STAND S
SUGGESTED USE
Stand S is a standalone anti-theft protection dedicated to
smartphones and tablets.
UMH3, UMH4 and DFO2 sensors allow aesthetic product
presentation.
Small size assures optimal visibility of the product.
Cleaning tissue with isopropoxide assures proper preparation of
the surface for Optiguard stickers.
1 / 5
Advertisement
Table of Contents
Summary of Contents for Optiguard STAND S
- Page 1 INSTALLATION INSTRUCTIONS STAND S SUGGESTED USE Stand S is a standalone anti-theft protection dedicated to smartphones and tablets. UMH3, UMH4 and DFO2 sensors allow aesthetic product presentation. Small size assures optimal visibility of the product. WARNING! After connecting the device to a charger, a periodically blinking yellow diode in the base indicates lack of any programmed remote controls.
- Page 2 INSTALLATION INSTRUCTIONS STAND S Through using the cleaning tissue with isopropoxide we can prepare the surface of the furniture which Stand S will be attached to. After cleaning the furniture wait until the cleaning substance evaporates. Take off the protective papers from the stickers.
- Page 3 Stick the phone to the sensor and press for approx. 10 seconds The smartphone will be simultaneously charged and protected. for good bonding of the sticker adhesive. Optiguard sp. z o.o. ul. Aleksandrowska 6-10, 87-100 Toruń NIP 956-213-03-91 3 / 5...
- Page 4 Plug the other end of the charging cable into the microUSB port microUSB port of the smartphone. of the UMH3 sensor. 19V/3.42A power supply provides enough power for Stand S and allows charging the protected product. Connect the power supply connector to the DC extension cable.
- Page 5 Powered Stand S will be activated within 3 seconds. Short acoustic signal and periodically blinking red LEDs in the sensor Plug the power supply with the Stand S connected to it into the electrical outlet (AC 230V). confirm activation of the system. Finished! Optiguard sp.
Need help?
Do you have a question about the STAND S and is the answer not in the manual?
Questions and answers