Advertisement
INSTALLATION INSTRUCTIONS
D206-LED
Large Flood
Slipfitter Installation:
1. Align the Slipfitter mounting holes with the (2) mounting holes on the rear side of the luminaire housing. (Fig. 1)
Fig. 1
Fig. 2
2. Place the Slipfitter against the housing, and route the Line, Neutral, and Ground wires through the arm.
3. Fasten the arm to the housing using (2) included 1/4-20 bolts. (Fig. 2)
4. Loosen the (4) set screws on the sides of the arm so that the pole will not interfere with the bolts.
5. Connect the Line, Neutral, and Ground wires from the pole to the luminaire using the appropriate connectors.
6. Slide the pole completely into the arm and ensure that the luminaire is at the desired angle.
7. Tighten the (4) set screws to fasten the luminaire to the pole.
Dimensional Drawings
Yoke Mount:
1. Drill (1) wire hole and (2) mounting holes using the dimensions in the attached diagram.
2. Connect the luminaire to the mounting surface using two included retaining bolts.
3. Feed the cable into an appropriate fitting to maintain a watertight seal.
Deco Lighting practices a program of continuous product improvement, and as a result product specifications change frequently. We reserve the right to change
2
product specifications without notice. Contact Deco for the latest product information.
2917 Vail Ave.Commerce, CA 90040
800-613-3326
info@getdeco.com
www.getdeco.com
•
•
•
Advertisement
