RAB Lighting FERN Pagoda LL Series Installation Instructions

FERN PAGODA INSTALLATION INSTRUCTIONS
TM
Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We'd like to hear your comments.
Call the Marketing Department at 888-RAB-1000 or email: marketing@rabweb.com
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. THIS PRODUCT MUST BE
INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND
OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF before installing or maintaining fixture. No user serviceable parts inside.
WARNING: For proper weatherproof function all gaskets must be seated properly and all screws inserted and tightened
firmly.
WARNING: MAX 12VAC ONLY.
WARNING: The main low voltage cable is intended for shallow burial - less than 6 inches (152 mm).
WARNING: Risk of Electric Shock. Install all luminaires 10 feet (3.05 m) or more from a pool, spa, or fountain.
GROUND MOUNTING
To mount Pagoda LL series, follow the steps below -
Feed the Fixture Leads from Shade into Stem. Rotate
1.
Shade and secure to the Stem. Be careful not to pinch
wires.
Hammer Spike8 into desired location on ground in such
2.
a way that the Wireway Slot isn't underground yet.
Note - To avoid damage to Spike8, place a board on
top of Spike8 while hammering.
Feed Fixture Leads from Stem into the Spike8. Pull
3.
Fixture Leads through Wireway Slot as shown in
figure and complete electrical connections using RAB
recommended connectors (ordered separately) to
transformer (ordered separetely) or Low Voltage Fixture.
Note - Pagoda/ LL series is supplied with 56 inches of
Fixture Leads out of the fixture.
Rotate Stem/ Shade and secure to Spike8. Be careful
4.
not to pinch wires.
Carefully hammer the Spike8 flush into the ground
5.
without damaging the Fixture Leads.
WARNING: To prevent wiring damage or abrasion, do
not expose wiring to edges of sharp objects.
LLFCLED6LV
LL1LED6LV
Stem
To the Transformer/
Low Voltage fixture
LL2LED6LV
Rotate
Rotate
Shade
Fixture Leads
Spike8
Wireway Slot