Gira Ward control centre Plus 5971 00 Short Instructions

GB
Gira nurse call system Plus
Short instructions
Ward control centre Plus 5971 00
Gira
Giersiepen GmbH & Co. KG
Electrical Installation
Systems
P.O. Box 1220
42461 Radevormwald
Phone +49 (0) 2195 / 602 - 0
Fax +49 (0) 2195 / 602 - 191
www.gira.com
info@gira.com
Safety instructions
Installation and mounting of electrical devices may only be car-
ried out by qualified electricians.
Failure to observe the instructions can result in damage to the
device, fire or other dangers.
Isolate before working on the device or load. Take account of all
circuit breakers supplying dangerous voltage to the device or
load.
Always connect protective conductors, see
i
Note: comply to DIN VDE 0834.
Observe the content of DIN VDE 0834 and any other applicable reg-
ulations.
Function
The ward control centre Plus of the Gira nurse call system Plus
controls and regulates the devices connected to the ward bus,
such as room terminals with and without speech module. The
device may be connected to the system central control unit via
the system bus (nurse call system Plus LAN, and "large system"
setting in the configuration assistant).
The Gira nurse call system Plus can also be controlled and regu-
lated from only a single ward control centre Plus without a system
central control unit ("small system" setting in the configuration
assistant).
All devices existing in the system are automatically recognised.
Devices can be integrated or removed from the call system at a
later time.
The ward control centre Plus is immediately ready to use. Addi-
tional settings can be carried out via the configuration assistant in
the device.
i
Note: read the system operating instructions.
Become familiar with all the possibilities of the device and the
complete call system. Please read the
system operating instruc-
tions and use the onscreen help information in the configuration
assistant. You can find the
system operating instructions
language variations on the CD-ROM.
Scope of supply
• Ward control centre with configuration software.
• Jumper for activating terminating resistances on the ward
bus.
• Connection plug for ward bus and power supply.
• System operating instructions in German and system over-
view plan (printed) and further languages as PDF files on en-
closed CD-ROM.
Installation
The ward control centre Plus must be installed in a dry, dust-free
and well ventilated location.
Installation is intended on a DIN top-hat rail.
Important! Danger of overheating!
With an unfavourable installation location, heat accumulation

may cause device overheating. This may cause damage. Ensure
in fig. 1!
sufficient air circulation to prevent heat accumulation.
Important! Do not install in patient's rooms!
The device must be securely installed.
Access to the device for skilled personnel must be possible at all
times.
Connections
The ward control centre Plus has the following connections:




Legend:

Earthed connection

Green LED

Yellow LED

+24 V/GND
Fig. 1: Ward control centre connections
Requirements for start-up
in further
The requirement for operating the ward control centre Plus is a
connection to the power supply and to the ward bus or system
bus.
- Room bus, ward bus and system bus (with "large system" set-
ting) are installed and ready for operation.
- The ward control centre is the first device on the ward bus.
With the last device on the bus, the terminating resistances
must be activated with the enclosed jumper.
Extern 834 Plus
LAN LAN
Station

Bus
   
VGA

External LAN RJ45

Nurse call system

Plus LAN RJ45
Power on

Ward bus
Bus active

2 x USB
DC power supply

VGA pin jack