Summary of Contents for LITETRONICS LED Vapor Tight Slim Strip Light
- Page 1 LED Vapor Tight Slim Strip Light Installation Instructions For 4’ and 8’ LED Vapor Tight Slim Strip Light (VT Series) PLEASE READ THESE INSTRUCTIONS BEFORE INSTALLATION...
-
Page 2: Safety Instructions And Warnings
SAFETY INSTRUCTIONS AND WARNINGS WARNING: READ CAREFULLY BEFORE INSTALLING STRIP LIGHT. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE. CRITICAL SAFETY INSTRUCTIONS: Installation should only be conducted by a qualified electrician in accordance with NEC and any relevant local building codes. Risk of fire or electric shock. Strip Light installation requires knowledge of luminaires electrical systems. If not qualified, do not attempt installation. - Page 3 Phillips Screwdriver Measuring Tape Drill Step Ladder WHAT COMES IN THE BOX LED Vapor Tight Slim Strip Light base product comes with following standard parts: IMAGE PART 4’ QTY 8’ QTY LED Vapor Tight Slim Strip Light Mounting Brackets Anchors Mounting Screws (#6 x 1 1/4”)
- Page 4 Section 1 4’ & 8’ VAPOR TIGHT SLIM STRIP LIGHT SURFACE MOUNT INSTALLATION READ ALL INSTRUCTIONS BEFORE BEGINNING INSTALLATION Turn off power at electrical panel. Determine mounting position and mark placement for brackets. Drill pilot holes for anchors. Note: For 4’ Installation- 2 holes required. (Extreme ends) For 8’...
- Page 5 Section 1 4’ & 8’ VAPOR TIGHT SLIM STRIP LIGHT SURFACE MOUNT INSTALLATION Place tooth lock washers (M4) over mounting screws (#6 x 1 1/4”), then through center hole of brackets and screw into anchors. Tighten brackets down and be sure to align in same direction.
- Page 6 Section 1 4’ & 8’ VAPOR TIGHT SLIM STRIP LIGHT SURFACE MOUNT INSTALLATION READ ALL INSTRUCTIONS BEFORE BEGINNING INSTALLATION Use anti spread hardware to prevent fixture from moving after installation. Slide anti spread screw (M3 x 40) through tooth lock washers (M3). Then slide screw through holes in back of brackets.
- Page 7 Section 1 4’ & 8’ VAPOR TIGHT SLIM STRIP LIGHT SURFACE MOUNT INSTALLATION Using wire nuts (not included), connect incoming wires with fixture wires following wiring diagram below. L (Black) ACL (Black) INPUT N (White) ACN (White) LAMP CABLE WIRE VAPOR TIGHT Green GND GND (Green/Yellow)
- Page 8 Thank you for choosing 6969 W. 73rd Street Bedford Park, IL 60638 WWW.LITETRONICS.COM CustomerService@Litetronics.com 1-800-860-3392 V4 (1-17-18)