Page 1
(((temporary title page))) Please read these instructions before using your FS/GS HUSKY FS/GS USER LEAFLET...
Page 2
USING YOUR FS/GS The FS/GS hand-held computer is rugged and waterproof, but to help ensure trouble-free operation, we recommend that you: • Check how to use your application before beginning work. • Carry a spare set of batteries • Avoid subjecting your FS/GS to: •...
Page 3
Note: Information refers to our standard model. Information on any differences should be included in notes from your solution provider. 1. RS232 CONNECTOR: serial/charging port. Referred to as COM2. 2. FUNCTION KEYS: press to use application functions. 3. POWER KEY: press to turn on or off. 4.
Page 4
CONTROLS Note: Your application's user instructions may supplement the following information. Turning on and off Press to turn on, or off. To conserve power, the FS/GS turns off automatically if you have not pressed any keys for a short while. Screen contrast Adjust the screen contrast for optimum readability, especially at temperature extremes.
Page 5
BATTERIES The FS/GS can be fitted with either rechargeable or replaceable batteries. The FS/GS batteries are designed to last more than a working shift. However, if power does run low, a warning BATTERY LEVEL LOW will be displayed. (After a further period of use, your FS/GS will turn itself off and will not turn on again.) You should do one of the following: Return the FS/GS to your base or office.
Page 6
Replacing batteries • Turn off the FS/GS. • Remove the battery cap by using a suitable coin. • Do not allow rain or moisture into the battery compartment. • Tilt the unit to slide out the batteries. • Slide the fresh batteries into the battery compartment, positive end first.
Page 7
CLEANING If the screen gets dirty or smeared, clean it with a clean cloth. If the FS/GS gets very dirty, it should be cleaned: • Turn off the FS/GS. Make sure that the battery cap is tight. If you have dropped it, check that the case and seals are intact.
Page 8
PROBLEMS If you have problems with the FS/GS, TELL YOUR SYSTEM PROVIDER, but here are a few quick checks: • If the unit will not turn on, check the batteries' orientation and try a fresh set of batteries. • If you cannot read the display, try adjusting the screen contrast (See Controls).
Need help?
Do you have a question about the HUSKY FS/GS and is the answer not in the manual?
Questions and answers