Hide thumbs Also See for HHO60TAMI:

Advertisement

Quick Links

MODEL NO.: HO60 AMI
H
T

Advertisement

Table of Contents
loading

Summary of Contents for Hisense HHO60TAMI

  • Page 1 MODEL NO.: HO60 AMI...
  • Page 2: Table Of Contents

    CONTENT SAFETY INSTRUCTIONS…………………………………..…………………1 INSTALLATION (VENT OUTSIDE) …………………………………..………3 START USING YOUR CHIMNEY EXTRACTOR……………………………8 TROUBLESHOOTING…………………………………..……………………9 MAINTENANCE AND CLEANING…………………………………..………9 ENVIRONMENTAL PROTECTION…………………………………..………12 WARRANTY CONDITIONS…………………………………..………………13...
  • Page 3: Safety Instructions

    SAFETY INSTRUCTIONS This manual explains the proper installation and use of your chimney extractor, please read it carefully before using even if you are familiar with the product. The manual should be kept in a safe place for future reference. Never to do: Always to do: ●...
  • Page 4 Always to do: Always to do: ● ● Always put lids on pots and pans when Caution: The appliance and its accessible cooking on a gas cooker. parts can become hot during operation. ● When in extraction mode, air in the room is Be careful to avoid touching the heating being removed by the chimney extractor.
  • Page 5: Installation (Vent Outside)

    INSTALLATION (VENT OUTSIDE) This appliance must be installed by a qualified electrician. If you have an outlet to the outside, your chimney extractor can be connected as below picture by means of an extraction duct (enamel, aluminum, flexible pipe or inflammable material with an interior diameter of 150mm) 1.
  • Page 6: By Put The Inner Chimney Into Upper Chimney .Then Pulling Out The Upper Chimneyupwards Adjust To Reach The Height Required.see Pic

    Screw (4mm x30mm) Holes on wall Screw plug Pic 2 Wall bracket 4. Put the cooker hood on the hook. See Pic 3. Pic3 5.By Put the inner chimney into upper chimney .Then pulling out the upper chimneyupwards. Adjust to reach the height required.See Pic 4 Pic 4 6.Fix the lower chimney with 2 pcs of 4x8mm screws.See Pic 5 Pic 5...
  • Page 7 7.Lay the expansion pipe to the wall outlet. Fix the expansion pipe with the cable tie on the wall-outlet.See Pic 6 Pic 6 MOUNTING OF THE V-FLAP If the chimney extractor does not have an assembled V-flap 1, you should mount the half-parts to the its body.
  • Page 8 HINTS FOR EXHAUST DUCT INSTALLATION The following rules must be strictly followed to obtain optimal air extraction: ● Keep expansion pipe short and straight. ● Do not reduce the size or restrict expansion pipe. ● When using expansion pipe always install the pipe pulled taut to minimize pressure loss. ●...
  • Page 9 CARBON FILTER-buy separately Activated carbon filter can be used to trap odors. Normally the activated carbon filter should be changed at three or six months according to your cooking habit. The installation procedure of activated carbon filter is as below. In order to install the activated carbon filter, the aluminium filter should be detached first.
  • Page 10: Start Using Your Chimney Extractor

    START USING YOUR CHIMNEY EXTRACTOR Push button/Electronic button 1 Off button It's used for turning off the fan. Low Speed button It's used for Ventilation on the kitchen. It is suitable for simmering and cooking which do not make much steam. Medium Speed button Airflow speed is ideally for ventilation in standard cooking operation.
  • Page 11: Troubleshooting

    TROUBLESHOOTING Fault Possible Cause Solution Fan switch turned off Select a fan switch position. Light on, but motor does Fan switch failed Contact service center. not work Motor failed Contact service center. Reset/Replace fuses. House fuses blown Light does not work, motor Refit cord to power outlet.
  • Page 12: Stainless Steel

    ● External surfaces are susceptible to scratches and abrasions, so please follow the cleaning instructions to ensure the best possible result is achieved without damage. GENERAL Cleaning and maintenance should be carried out with the appliance cold especially when cleaning.Avoid leaving alkaline or acid substances (lemon juice, vinegar etc.) on the surfaces. STAINLESS STEEL The stainless steel must be cleaned regularly (e.g.weekly) to ensure long life expectancy.Dry with a clean soft cloth.
  • Page 13: Bulb Replacement

    INSTALLING GREASE MESH FILTERS To install filters for the following four steps (See pic below): - Angle the filter into slots at the back of the hood. - Push the button on handle of the filter. - Release the handle once the filter fits into a resting position. - Repeat to install all filters.
  • Page 14: Environmental Protection

    ENVIRONMENTAL PROTECTION This product is marked with the symbol on the selective sorting of waste electronic equipment. This means that this product must not be disposed of with household waste but must be supported by a system of selective collection in accordance with Directive 2012/19/EU.
  • Page 15: Warranty Conditions

    Units that are supplied through rental channels carry a 2-year warranty only, please consult with these channels or Hisense South Africa regarding the warranty period and conditions. The warranty does not apply to Hisense air conditioners, please contact our agents / original retaileror distributor for warranty conditions for air conditioners.
  • Page 16 3. Hisense is in support of the Consumer Protection Act 68 of 2008, and in the first 6 (six) months from date of purchase, for valid warranty claims, the product will may be repaired or exchanged by the Hisense, or credited by the dealer / store once approved by Hisense.

Table of Contents