Waterworks Exeter Series Installation Instructions

INSTALLATION INSTRUCTIONS
For Exeter 2-Piece Water Closets
To ensure this product is installed properly, please read these instructions carefully before you begin.
(Certain installations may require professional help.) Also be sure your installation conforms to local codes.
!
CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE
INJURY HANDLE WITH CARE!
NOTE: Pictures may not exactly define contour of china and components.
RECOMMENDED TOOLS AND MATERIALS
Putty Knife Regular Screwdriver
Hacksaw Wax Ring/Gasket
1 REMOVE OLD TOILET
a. Close toilet supply valve and flush tank completely. Towel or sponge remaining water from tank and bowl.
b. Disconnect and remove supply line. NOTE: If replacing valve, first shut off main water supply!
c. Remove old mounting hardware, remove toilet and plug floor waste opening to prevent escaping sewer gases.
d. Remove closet bolts from flange and clean away old wax, putty, etc. from base area.
NOTE: Mounting surface must be clean and level before new toilet is installed!
2
ROUGHING-IN DIMENSIONS:
ELONGATED (EXWA40)
1 1/4"
28-1/2"
FINISHED WALL
8-3/8"
C/L OF SEAT POST
MTG HOLES ON
5-1/2" CTRS
18-7/8"
1/2"
3-1/2"
13-5/8"
6-1/2"
12"
C/L OF OUTLET AND
TOILET MTG BOLTS
Adjustable Wrench
Supply Tube
ROUND FRONT (EXWA36)
1 1/4"
FINISHED WALL
26-3/8"
8-3/8"
C/L OF SEAT POST
MTG HOLES ON
5-1/2" CTRS
1/2"
3-1/2"
6-1/2"
12"
C/L OF OUTLET AND
TOILET MTG BOLTS
Sealant Tape Measure
Closet Bolts Carpenters Level
16-7/8"
13-5/8"
18-3/4"
C/L
15"
31-1/4"
16-5/8"
8"
*
11-1/4" FINISHED
FLOOR
* 6"
C/L OF SUPPLY
AS REQUIRED